Power supply projector getting on but lamp not glowing

1,Check the fans ,whether each fan is running,when you turn on the projector
2,if the fans run, then ,check the lamp or lamp ballast



I am an expert of repairing projectors for 19 years.
It is my pleasure to receive the message form you,
WhatsApp ID:+8613178867858
Skype:[email protected]
Wechat ID:+8613178867858
Email:[email protected]
Email:[email protected]
Mobile:+86 13178867858
http://www.lampdeng.com

the projector is turned off for two reasons ventilation or power supply has to prove who are working on special turbine

1,Check the fans ,whether each fan is running,when you turn on the projector
2,if the fans run, then ,check the lamp or lamp ballast

Have a nice day!
We supply original projector parts: lamp, bulb, Lcd panel, Lens, DMD chip, color wheel,
motherboard, powersupply ... with high quality and competitive price.
Lampdeng Limited
Jerry

sounds like the bulb will not fire up. most likely cause is the bulb needs replacing

hi,
If the lamp light is solid orange then, the lamp of your projector is faulty. You have to repalce the lamp.
ok

Looks like there is power supply problem as well as the lamp.

1 Clean all filters
2 Check out power supply (usually a few capasitors need to be replaced)
3 Wuld be a good idea to check the lamp in wokring projector, but if the "Lamp" light is constantly on it is more likely a faulty lamp as well.

Hello
If the Lamp light and power lights are blinking orange, the lamp driver has failed, and the projector will automatically shut down. Unplug the power cord from AC mains wall socket, wait for three minutes and replug and see whether it helos you. If not, contact Dell service center.
OK.

turn on the projector ,at the same time ,if you can hear a continuous beep beep sound (the ballast igniting the lamp)
means the lamp is fault,and other parts is working well

Have a nice day!
We supply original projector parts: lamp, bulb, Lcd panel, Lens, DMD chip, color

wheel,
motherboard, powersupply ... with high quality and competitive price.
Lampdeng Limited
Jerry

Sound pretty much like a dead lamp. Problem could be a fan problem or heat sensor or power ballast. We supply lamps internationally so can assist if required as we ship world wide. Regards Kevin Andreassend http://www.iceav.co.nz [email protected]

Hi

Does your projector still work?

The warning lamp is there to let you know there is a problem, usually overheating! Make sure it is well ventilated and that the filters have been cleaned.

Try disconnecting the AC power cord and then reconnect it to check if it is still happening.