Compatibility Was just wondering if the eclipse EA3422 Amplifier is large enough to power eclipse 8052 component series and eclipse SE8495 6x9's or that also could be the reason the speakers cut out when the volume is turned up. could it be that they are just under powered?

http://www.manualsdir.com/manuals/82385/eclipse-fujitsu-ten-eclipse-da7232.html?page=10

Your Eclipse unit goes into protect mode when you blast the music to loud. Internal components probably failed and will have to be replaced to restore normal operation.

Whatever the watts is on amp

Check your ground and power wire connections. It will most likely be a bad ground, if grounded in the trunk, get a longer wire of equal or greater thickness and ground to either chassis or battery. Also if you have the amp at full gain try dropping it a little back if getting a better ground doesnt help

this is the manual and you will find all you need in it.

http://www.fixya.com/support/p78783-eclipse_ea3422_car_audio_amplifier/manual-18248#

forget hooking this on a subwoofer. this amp produces only 50 watts per channel at 4ohms or 70 watts per channel at 2 ohms RMS...
If you try bridging the sub, it will only give out maybe 100watts bridged.
So..... if your sub is, lets say 1000watts RMS, youre just going to bust your amplifier to smoke...
Find a more decent and powerful amp. This amp is only intended for separates and lowend subs with an RMS of 80 to 150 watts

depending on the power consumption of the amp u will need to run a 4-12 ga wire to the positive battery terminal. then u need to ground it with a wire connected to a clean ground like a chassis bolt. next u need preamp outputs on ur deck to send audio signals to the amp. lastly u need to hook up a remote wire to the blue wire in ur cd player harness

double check your remote wire as i had the exact same problem and my remote wire was faulty

reconnect the new wire or check the component inside the amp....component number are f41

Your problem is with your stereo/radio, not your amp... Take a friend amp and connect it up as you have yours and see if it does the same thing.