Loud tapping noise from carberator

The tapping is the valves hitting against the buyer upper part of engine. The stalling is most likely the computer shutting down engine. You might have engine damage. The tapping comes and goes according to engine rpm the higher the rpm the louder the tapping. If I was have it towed to u mechanic and have them run test engine might be beyond repair

loud knock and for how long

is it a diesel or petrol

broken engine mount

loud tapping is tappets ..should go away once oil reaches top of motor
water pump or bearing something running off drive belts

if high milage engine
a loud knock at engine revolution or half revolution
big end bearings or
piston slap or gudgeon wear

might be the valves have been damaged running without oil
- or the crankshaft / camshaft / main bearings
most probably you have to let the engine be rebuilt by a mechanic
(expect cost of more than US$ 2.000)
or get another (used) engine at a scrapyard

Most likely cause is a hydralic tappet. Mits are well know for top end noise. Note we are talking about a tapping or clicking sound not a knock. You can try using an engine flush product if the noise is getting bad and then changing your oil. Generally if the oil is not changed regularily eventually the tapping noise gets happens.

sounds like your tappets need adjusting ,

sounds like another bad hub brg, jack up front end and check for play in wheels from top to bottom wiggle for movement. A loose wheel brg will set a front speed sensor code.

are you getting oil pressure when the car is warm have you changed the oil recently or is it overdue if you have an oil pressure gauge on your dash check to make sure you are getting propper oil pressure as this is what it sounds like you are losing oil pressure and your valves are tapping.

Remove the valve cover and rotate the engine and check to see if all the valves are opening the same amount. If not, you have either a bad lifter, bent pushrod, or cam going flat. Check your valve lash with the valves closed. You should be at 0 lash at all of the rocker arms.

the noise is from the fuelpump have to replace it .

Sometimes the fuel injectors make noise simular to lifters