No flash w/code e:91:01 on sony dsh-h2

hiyes, you can get service at your local place. it is quite easy problem. it would have either brown fuse or defective flash unit. local repair shop would charge around $45 to 135 depend on what they really want to charge.

Probably just a burned out bulb or a disconnected wire. Try taking it to a Radioshack and see if they can take out the bulb for a replacement. Shouldn't be that difficult to replace.

1.pls call your sevice provider from an another cell of same sevice provider
& tell your details , then they will tell your puk code
OR
it is in the sim itself

Hi

Thanks for using FixYa. Please click on the link to download the manual:

Sony DSC-H2 Manual

Please do rate the solution if the issue is resolved or post a comment for further assistance.

Thanks

Rylee

You need a new release assy

https://servicesplus.us.sony.biz/sony-parts.aspx#

Part Number X21083252

To replace involves removal of :

Rear Cover
LCD
Circuit Board
Lens Unit
Flash Circuit

Once those are out, you can twist the old release button unit out and refit the new on inreverse order.

Just go in "menu", "set up 1", "initialize", and select "ok". With that you will reestart your camera. I already did it twice in my DSC-H2 and the flash came back to work. Goo Luck!!

take it for servicing

To enter the serviceman simulation mode, press the keys as follows:
Clear → Density select → Clear→ Density select
To cancel the simulation mode, press the clear key. Then enter code 14 then hit start.

You need to use you fingernail and pop off the entire button assembly. When you have done this you will be looking inside your camera.

Set the new button assembly into the slots. It will not want to go on by just pushing down. The plasitc assembly is very slick so put a small piece of scotch tape the yellow stuff. I put the tape around the plastic assembly. Make sure you are only putting tape on the chrome plastic assembly. The reason for the tape is to get a good hold of the plastic asembly.

Once you have the tape on the assembly/chrome piece you need to really push down and twist clockwise. You will hear a click and then another click. Make sure you hear two clicks. I had to push and twist pretty hard to make it lock into place.

Sony Blinking Codes
http://www.iwaynet.net/~nesda/SonyBlink.html