Spark Plug for Briggs & Stratton Engine

The oil plug on the Briggs & Stratton 5.5 HP quantum engine is usually located at the bottom of the engine near the crankcase. It should be a round metal plug with a hexagonal head and a rubber or metal gasket. You may need to use a box or adjustable wrench to remove the plug. Once the plug is removed, you can add the necessary amount of oil to the engine.

How to Change Oil ' Briggs & Stratton
https://www.briggsandstratton.com/na/en_us/support/maintenance-how-to/browse/how-to-change-oil.htmlMaintenance Kits & Tools Briggs & Stratton Online Store
https://shop.briggsandstratton.com/collections/maintenance-kits-toolsFind the right spark plug and gap for engine ' Briggs & Stratton
https://www.briggsandstratton.com/na/en_us/support/faqs/browse/identifying-the-correct-spark-plug-and-gap.html

What is the right spark plug and gap for my small engine Briggs Stratton ..look at this page it might help you out

How to Gap a Spark Plug - YouTube

? 2:57
https://www.youtube.com/watch?v=IuW3svdqKZM
Oct 15, 2012 - Uploaded by ChrisFix
How to correctly gap a spark plug. This is a fast and easy video on how to gap a spark plug and spark plug gap ...

FAQ: Find My Engine Spark Plug & Gap ' Briggs & Stratton

www.briggsandstratton.com/.../identifying-the-correct-s...

Briggs & StrattonFollow this step-by-step image guide to locate spark plugs in different Briggs & Stratton engine types. ... Spark Plug Type & Gap Chart for Briggs & Stratton Engines. Now that you've found the part you'd like to replace, you can use the chart below to identify the genuine Briggs & ...

Spark Plug Gap - AutoZone

Identifying the Correct Spark Plug and Gap

What is the correct spark plug and gap for my engine?

Due to the variety of engine and equipment configurations, your best source for spark plug information is your engine or equipment Operator's Manual. However, the following general guidelines will get you pointed in the right direction.
This guide provides the common spark plug part numbers used in our L-Head and Overhead Valve engines. For information regarding the service/replacement of spark plugs, please visit our Servicing the spark plug FAQ. Please be aware that the size/shape of the spark plug varies depending on engine design.

Briggs & Stratton L-Head Engines
(also referred to as Flat Head or Side Valve Engines)

Fouled plugs may be caused by oil leaking into the cylinder. Does it smoke when running (cold), are you using up the crank oil. Black smoke is excess gas comsumption, blue smoke is oil burning. If your plug is fouled with black carbon, you are most likely running to rich.

Check for spark from the coil if you have a spark tester use it if not remove plug and leave it attached to the coil wire turn engine over if you do not have spark either the ground wire is not releasing or coil is bad

If you are having problems starting your mower you should check 3 things, air, fuel and spark.

Fuel: check to make sure you are full of good quality fuel, try to start the engine several times then take out the spark plug and it should look wet. If its not wet then you aren't getting fuel into the engine.

Air: remove and clean the air filter with clean gasoline if its made of foam. If its made of paper then you should buy a new one from a local auto parts or hardware store.

Spark: disconnect the spark plug wire from the spark plug and hold the wire close to the engine block. Try to start the engine and watch for a spark to jump between the end of the wire and the engine block. If it doesn't then either the wire is bad or the ignition coil is bad.

Reply to this solution when you find the problem and I can tell you how to solve it.

Check engine oil.

Remove wire from low oil sensor and the start.

Replace low oil sensor.

Hope this tip help solve your problem.

r/David

Home Depot has the plug you need for briggs 6.5hp engines. Don't worry about it being a Murray. Buy a Briggs 6.5hp plug.

use a champion RJ19LM spark plug, you will see that the engine is built by briggs and stratton.hope this helps