I need a remote control bass knob and cable for a Legacy LA590 2

It is actually in the controller, if you turn the remote all the way down and press on the controller until the bass goes off, you will be able to turn the bass up and down with the remote, mine worked but stopped after a month, I tried adjusting the amp but then I noticed that if I wiggled the knob on the remote that it would work, I mashed mine until it worked again and velcroed it to my console sonibcan get it on and off easily.

BLAST Port (Bass Level And Signal Transfer) Provides Remote Bass Level Control and control signal transfer between multiple SX amplifiers

Here is the manufacturer's accessory page to the remote: http://www.kicker.com/zxrc

Here is one on eBay: http://cgi.ebay.com/KICKER-2010-10-ZXRC-AMP-AMPLIFIER-REMOTE-BASS-CONTROL-/360328112100?pt=LH_DefaultDomain_0&hash=item53e53aa7e4

And here is a note from Kicker on how to make a control yourself for strapping multiple amps together: I have two or more Kicker SX or KX subwoofer amplifiers. I don' t want to use all those separate bass level controls. Is there a way to make them all work with a single Kicker control knob?
Yes. You can visit your local Radio Shack or home improvement store and purchase an RJ-11 modular adapter. You then plug the sub level cables from the individual amplifiers into the adapter. Then run a cable from the adapter to a single Kicker remote knob. All amps will now work with a single knob.

if its a legacy order it from legacy...com i might be pricie$$

it helps with matching volume control

i would not worry about that really you dont need it i know install more than five hundred of them

ebay ABR100t i do believe

I'm wanting to know the same thing... But be careful on the pin out of the control you get.

I have an audiobahn 2300HCQ amp... Before I had the 1800. The 1800 came with a remote with 6pin remote cord. I got the 2300 used and did not get a control for it. The plug on the 2300 is a 4 pin plug... I can't figure out how to cross it over correctly to get the 1800 remote to work on the 2300.

I have tools to crimp an end... Just can't figure out the color pin out.

i don't think you'll have any problems if the hook up will fit. i myself have a lighting audio bass knob hooked up to a jensen amp and haven't had any problems from that

most amps comes with specific controlls finding a controll will be a little difficult,what knob, is it the one one the amp or the remote one?

dont try that yet,doesnt require remote to work,only added feature