The camera was working fine the last time we used it and when we started to take a picture, it wouldn't turn on. We put new batteries in it and it still won't turn on.... it hasn't been dropped or anything, so we have no idea why it won't work. They had the same kind of camera at my husbands work and it stopped working just like ours has. We would like to know if this is something that can be fixed.... and where can we take/send it to be fixed. Also, how much it would cost....
SOURCE: cannon powerShot S2
Unfortunately this issue is most commonly caused by an electrical failure with the camera's power unit. Sometimes a hard reset will work, though I'm not sure if permanently.
Usually the solution is to call Canon's tech support and have the unit sent in for service. To give the reset a try however turn your camera on and immediately press and hold the Menu button for approximately 7 or 8 seconds (until you get a Reset Camera message). If you can get this far, do the reset and then power down the camera.
Then remove the memory card, the batteries and the date/time battery unit (a small rectangular door located inside the main battery well). Once all batteries are removed, turn the camera's power switch into the on position. Wait two minutes then press the power button as if turning it off. Then replace all batteries and the memory card.
Turn the camera back on and immediately set the time and date.
Turn the camera off and on a few times and take a few shots if possible. This works in about 25% of the time. If it doesn't and you have confirmed that the battery itselef is good (by placing it in another unit typically) then the camera will typically have to be sent in for a service repair.
Hope this helps.
Sincerely,
HeavyDLB
SOURCE: Cannon PowerShot S2 IS lens is stuck
I have the exact same problem, took it completely apart removed the zoom motor, physically turned the zoom gear and retracted the lens, reinstalled the motor, put it all back together, and found that I had the same problem and the lens wouldn't move out, so im pretty certain that the motor is bad, as the lens moves smoothly once the motor is not attached to it... looking for a replacement motor as i type...
SOURCE: Canon PowerShot G2 buttons don't work
You have a bad button board . This is a single board with a series of small button switches that control all these functions. Most repair shop will charge around 75.00 to fix.
SOURCE: my Canon S2 IS Powershot camera LCD screen turned black
A stuck shutter is another common failure mode for digital cameras, ESPECIALLY for the S2 IS (you should actually complain to Canon at 1-800-OK-CANON. If it is indeed a sticky shutter, they have been fixing this for free). The symptoms of a stuck or "sticky" shutter are very similar to CCD image sensor failure. The camera may take black pictures (for shutter stuck closed), or the pictures may be very bright and overexposed, especially when taken outdoors (for shutter stuck open).
To confirm a stuck shutter, put the camera in any mode other than "Auto", and turn the flash OFF (you don't want to blind yourself for the next step). Next look down the lens and take a picture. You should see a tiny flicker in the center of the lens as the shutter opens and closes. If no movement is seen, then you likely have a stuck shutter. If so, please see this link for further info and a simple fix that may help. Hope this saved you $99.
SOURCE: Battery low indicator on Canon Powershot A470 camera is always on
You're using alkaline batteries. No matter how much you pay for alkaline type batteries, they just cannot cope with the amount of power that a digital camera needs - especially an older model. Use a type called lithium AA, energiser make a very good version. You can usually buy them in camera shops, and they can be a little pricier, but the camera will take between 300-500 photos per set, so worth it. If thats not possible I would suggest using rechargable batteries with a charger - the higher the number the stronger the battery. 2100mAh to 2900mAh should be okay for a camera, and the best type is niMH (not niCD). Good luck.
884 views
Usually answered in minutes!
×