K tec hp3 parts - K-Tec Champ HP3 Work Top Blender

You don't say what is making them stick together or what you've tried to do. Gentle heat is usually helpful and sometimes hot water can dissolve the "glue" that's causing the problem. If the pitcher is used for sweetened drinks or if it is a small pitcher used for milk or cream, the hot water can do the trick.

they dont provide phone service but still i will try to get some info

The bearing and seal are not replaceable. The bearing is sonically welded into thte base of the jar. The K-Tec is made by Blend-Tec, and any of the Blend-Tec jars will work as a direct replacement.

Remove the 2 screws from the bottom of the base, release the 4 clips on each side and remove the bottom cover.
There is a fan blade attached to the bottom of the motor and a sensor on the side of it that senses the fan blade turning. If the sensor does not sense the fan blade turning, it assumes that the motor is locked up or 'overloaded'.
Check that the fan blade has not come loose from the motor shaft and reattach if necessary. Verify that the sensor is secure in it's housing next to the fan blade.
Reinstall the base cover and verify operation.

Blender keeps running. To use it I have plug and unplug it.
Virigl

That burning smell is kind of a death sentence. At least a switch or more likely coils are burnt out.

you might have to order a new container, because i have not been able to find individual parts for sale. however, you might try and call the manufacturer, because sometimes you can order replacement parts.

Usualy there is a rubber ring araound the bottom of the blade. If it gets worn out or out of posistion it may start to leak. Also if you dont have everything screwed in tight enought it could leak as well

A little late, but Blendtec and K-tec are one and the same. Their jars will work.

you will need to buy a new blender the motor for your blender is burning and it is difficult to get parts for it.goodluck.