Which fan do I need to buy to replace in my 60pl9200d/37

yes you need to replace the lamp part # 928138905390 , you can find this lamp every where on the internet or ebay , to find the lamp you most take the back cover off and you would see the lamp is very easy to replace

Look in the manual. (Page 4)

Turn the TV on From main supply: Ensure that the main supply is turned on. A blue indicator light on the front of the TV lights up. When the TV is turned on by the main supply, the blue indicator light will blink for 45 seconds. This is the lamp's start-up period. When the light goes off, press the POWER button on the remote control or power switch. Press POWER to turn on the TV.

http://www.retrevo.com/support/Philips-60PL9200D-TVs-manual/id/633ag423/t/2/

Telephone number Philips Customer Care Center: 1-888-PHILIPS (744-5477)

There is always hope, when was the last time you changed the bulb? Although this sounds like an overheating situation, check and make sure all the cooling fans are working in the back, if not replace them or have somone check out the circuit boards that control them.

U hear alots of clinking too,when tv power on and the projection lamp tried to come on?Yes,tv have a problems with it board call the Ballast board also.This Ballast board only job is to help ignite the tv projection lamp.

my tv flashes 6 times slow,pause,5 times fast but it dont power on

If the power button is displaying the bulb fault indicator AND overheat indicator lights at the same time, it indicates a faulty cooling fan. The television is smart enough to detect when either of the two cooling fans in the chassis have failed, or aren't spinning fast enough. To prevent overheating and damage, the set will not turn on if a fan is faulty. You'll need a replacement fan.

replace light engine (optical block)

Did you change the lamp yourself or was it serviced,and when it was changed was the ballist(s) messed with? It may be the ballast that caused the problem to begin with.

60PL9200D/37 When I unplug it for a while and turn it back on, the picture starts to come on, but it turns dark. And the red lights on the left and right side of the power button blink. Sound but no picture.

More than likely the problem is the CRT fluid and not the tube. Do a few google or fixya searches on CRT fluid and to get an idea of what it looks like when it gets cloudy.