Stanley Bostitch Pc2000 Staple Gun Tacker & Staples - Answered Questions & Fixed issues

Open the chamber and drop the staples upright in to the chamber do not try to load the staples by placing them on the strip that pulls out as you do with most staple guns.

It should be. It is held together by 7 screws. Generic help and videos https://www.google.com/search?q=Stanley+TRA700+electric+staple+gun+spring+came+out ..

Question edited to add CAPS. 1/2" or 5/8" only. https://support.stanleytools.com/hc/en-us/article_attachments/360012708258 ..

We have a similar answer to this here: https://www.fixya.com/support/t25987938-need_manual_stanley_tra700_elec_staple

Double check your using the correct size staples, there are a lot of different sizes and types out there. I've made that mistake. The most common reason is that it has jammed on a staple. remove the staples and the rod that holds them in place. See if the stapler will work when empty. Keeping you hand away from the trigger arm Carefully look to see if there if a staple jammed in the release slot. Sometimes you can clear jams with a small, flat blade precision screwdriver.

No, the TRE300 will require a wide crown staple. The staples that will work with the TRE300 are the TRC600 series( TRC604T 1/4" TRC605T 5/16" TRC606T 3/8").

Arrow T-50 heavy-duty staples 1/4-in to 3/8-inch

Replace the magazine. The catch must be worn. Make sure you get the right model. https://www.google.com/search?q=Stanley+Brad+Nailer+replacement+magazine ..

try stanley

I just used it 10 minutes 3and it won't do anything

no fuse

check on youtube just like anyone else can

The size & code of staple is usually on the side of the tool , ie 80/ 14 means it takes an 80 series staple & max staple length it can take is 14 mm. Hope this helps

Try contacting Stanley Bostitch to inquire.

Strip it down and clean it out, or at least get an airline in there. It is either rust or something inside breaking down. https://www.google.com/search?q=Stanley+Sharpshooter+electric+staple+gun ..

https://www.youtube.com/watch?v=jlpoXM7pgEo it shows it not catching but explains assy pretty well

Contact Stanley to inquire about a source for the staples.

In my limited experience the common fault with this type of staple gun is the safety lockout that prevents operation unless the stapler is pushed against a surface - the ones I have seen are flimsy and poorly constructed as if they are a complete afterthought and added by a junior in the drawing office...

Contact Stanley to request an assembly diagram.