Westpoint TV-201 Microwave Oven - Answered Questions & Fixed issues

Should be about 365 degrees Fahrenheit; if that helps. If you need further help, I’m available over the phone at https://www.6ya.com/expert/david_29ad5d1dd86564b0

Try:

https://www.2instructions.com/results_mm.php?marque=WESTPOINT&materiel=Dishwasher

There are two fuses in a microwave oven, and for the non-heating problem the problem is the high voltage fuse, incapsulated between the transfo and the magnetron. This supports up to 5000V and usually rated something like 0.65A/0.7A/0.8A and even 1A.When you open the capsule, you'll see it sitting there between its two connectors, and you'll notice the filament inside the glace is broken. Buy a new one and your machine will work like a horse.NOTE: Try to get the same ratings fuse, or else the oven will smoke and smoke the house with it, so be careful.The other fuse is smaller, and usually ceramic one, which can be found on the PCB, if that goes, you should get no power at all to the machine. If not sure, let a professional do the job, it's safer.

Hi,
Here is a tip that will help you to figure out what is wrong with yourMicrowave Oven....

Microwave Oven Basic Troubleshooting Tips

heatman101

Hi,

Here is a tip that will help you to figure out what is wrong with your Microwave Oven....

Basic Microwave Oven Troubleshooting Tips

heatman101

Normal 0 MicrosoftInternetExplorer4 /* Style Definitions */ table.MsoNormalTable {mso-style-name:"Table Normal"; mso-tstyle-rowband-size:0; mso-tstyle-colband-size:0; mso-style-noshow:yes; mso-style-parent:""; mso-padding-alt:0in 5.4pt 0in 5.4pt; mso-para-margin:0in; mso-para-margin-bottom:.0001pt; mso-pagination:widow-orphan; font-size:10.0pt; font-family:"Times New Roman";} Hi,

Here is a tip that will help you to figure out what is wrong with your Microwave Oven....

Microwave Oven Basic Troubleshooting Tips

heatman101

It is not advisable. The door is a critical safety part of the microwave oven. The glass being gone will allow heat in areas of the door not designed for heat. The glass also is a support for the safety mesh that contains the microwave energy to the cavity.

This can start when food splatters on the inner door, then from that point the microwaves that do the cooking are attacking that splatter eventually burning a hole in the door. Do not use the microwave oven in this condition. You will need to have the door parts that are damaged replaced

puk code for +918095649347

Are you certain there is no metal or metal containing racks or dishes?

BTW, wire racks (round wire) are ok because the microwaves travel around the round wire. Flat metal reflects and causes arcing.

Thanks for your question at FixYa.com

The waveguide cover will need to be replaced.

It provides critical protection for the magnetron.

You can contact Oster at the number in your owner's manual to see where you can order a new one.

If for some reason you do not have your manual, try 1-866-866-6283.

We're happy to help you with free advice and we'd appreciate your thoughtful rating of our answer.

You can but you may have uneven or hot and cold spots present in whatever you are heating. Sounds like the carousel motor has failed, those are replaceable. Good luck !

sounds like the water valve . ck it for rust of hard water build up as if the water can't get through it it will not fill . water should be up to the element . or about 2 1/2 gal .. if water is not in tank add some and se if it works then ck the float to make sure its ok. the buzzing could be the motor hum . **** hope these hepled to find the problem .. **** .

I wouldn't recommend to use the microwave to boil water. Here you can read the reason why: http://www.snopes.com/science/microwave.asp

Water can 'explode' when heated in a microwave under certain conditions. Best way to boil water should either be using a water boiler or an old-fashioned kettle.

First, check your owner's manual. It should address interference issues.

You can download GE owner's manuals and installation instructions here if needed.

Also check with Direct TV customer service to see what they recommend.

Microwaves manufactured after a specific date are required by the FCC to have a noise filter built in.

You can contact GE customer service to see if yours has one. GE Customer Service is here.

If not, you may be stuck unless the dealer will let you exchange it for a newer model.

We're happy to help you with free advice and we'd appreciate your thoughtful rating of our answer.

You should contact L.G. UK customer support or customer service here.

If you are not in the UK, please reply back with your country.

We're happy to help you with free advice and we'd appreciate your thoughtful rating of our answer.

The High Power Transformer (Magnetron) fuse is wrong. Replace it. It will work perfect... The fuse is always hidden in a plastic case fixed at the bottom of the microwave near the big capacitor... My email: [email protected]

Don't use it! Unplug it and take it back to the dealer-sounds like a loose wire or short.

This is not a make that we know in North America and appears to be an African make, Tanzania? The reasons for over heating compressors are Condenser fins blocked with fluff. The reason for a compartment not cooling is lack of refrigerant gas or blocked condenser fins. Clean the condenser with a brush and a vacuum. If that doesn't fix it, you need a Service Call or a new one (depending on age and condition). https://www.google.com/search?q=westpoint+refrigerator+model%23+wnmn-4117.ER ..

An internal fuse could be open.