20 Most Recent Kenmore 96610 / 96611 / 96612 / 96614 / 96619 Electric Kitchen Range - Page 9 Questions & Answers

This video link might help ... it is generic and NOT specific to Kenmores Range Stove Oven How to Find the Model Number Good luck on your troubleshooting

Kenmore 790 Model Induction Cooktop Error Codes Sears PartsDirect Take a look at this link ... for model 790 it indicates that error 35 is: Improper power supply voltage (low voltage) or failed wiring connections Check: Disconnect power. Check the power supply wiring. Have an electrician check the supply voltage. If the connections are good and the voltage is normal, the main power control board or filter control board is defective. So it may need a new control board...

hello Joe, the first thing I think of, is that there is a short-cut with the ground wire. These short-cuts can be caused by several things. for example humidity, but also a burned insulation. You have to check that. ALWAYS BE CAREFULLY WITH ELECTRIC AND UNPLUG THE COOKER BEFORE OPENING IT. I hope this helps, Dik

this might be normal behavior is the unit still heating and boiling items? has the unit worked differently in the past? see below Why the smoothtop radiant cooktop element cycles on and off

1. Save as PDF
2. Share

Table of contents

Does the radiant heating element cycle on and off?

• The surface cooking area may glow red when a heating element is ON.
• Some parts of the surface cooking area may not glow red when a heating element is ON.
• The warming zone element (on certain models) will not glow red.
• Radiant elements have a limiter that allows the element to cycle ON and OFF, even at the HI setting, to prevent damage to the ceramic cooktop. This is normal operation.
• The radiant heating element retains enough heat when off to provide a uniform and consistent heat. The surface will still be hot even though the element has cycled OFF.
• Cycling at the HI setting is normal and can occu

hello Lorraine, Most gascookers heve the possibility to change from LPG to natural gas. You need to change the injectors. The holes in the injectors for LPG are smaller that the ones for natural gas. I send you a link of Ebay where you can see what you need to look for. Sometimes the oven can give a problem when it is gas too. Kind regards, Dik 14results for natural gas cooker nozzles

Hello, there are always a lot of problems with the timers. Of course you can replace the timer, but they are often very costly. But you can bypass it. Google on "how to bypass the oven timer" and you will find suggestions. IF YOU ARE NOT FAMILIAR WITH THIS KIND OF WORK, THEN LEAVE IT TO A QUALIFIED ENGINEER The link I send you is just for information. Succes, Dik Well found you when tried to bypass my timer too For

Hello Sara, I think you have a gasoven too? in that case I think it is the flame safety device. when that is gone, the burner goes on very low, although it looks like all went well. It looks like the one I send you in the link, it is on the side of the oven burner. I hpe this helps you, kind regards, Dik Electrolux Tricity Bendix Oven Safety Device HG Fsd Solenoid 359070604...

F11= problem communicating with display Suggest you unplug unit, peel off front of display and clean this and contacts thoroughly. Replace - all should be good.

The error code E0-F2 indicates that your touchpad has a stuck key. You might try disconnecting the electricity from the range and pushing and releasing the buttons on the touchpad several times. Be aware as you push them of any button that feels different. If you notice one that is stiffer or just doesn't feel like the others, give it several more pushes. Worst case scenario, you will need to replace the touchpad.