clipper the description above and the model do not match. Are the blades not aligning after you change them or are they not aligned straight out of the box? Please call Andis customer service at 1-800
...Clipper (Model: 8554 Q. How do I align my blades? A. ALIGNING BLADES The bottom blade holes are larger than the shanks of the blade screws. When the blade screws are loosened the bottom blade can be ...
...blades. Also, the clipper itself should not need to be disassembled to be cleaned out and lubricated. Just the blade will snap off the end, and you can brush it out use a liquid blade wash to ...
...align two blades together. Hold the blade compartment in your hand upward with smaller blade on top of the larger blade. On the clipper in between the two hole where screws go there is a small arm ...
...putting it back together put a drop of clean oil between the blades. Also make sure it it adjusted properly. Maybe you just need to clear them. blade out of ...
...crisp as the right side...i have them align properly,,, iused the annivo blaed setter may need clipper blades sharpening but without testing its hard to tell send them to ...
...dial it back till it runs smooth. if that does not fix the prob, your blades might not be aligned ...
...clipper increases substantially. Then turn the screw back out, slowly, until the sound decreases again. Turn another 1/4 to 1/2 turn. Unless something else is wrong, this should take care of the ...
...BLADES FOR MY ANDIS LINER BUT IT STILL DOES NOT CUT SMOOTH AND SHARP. WHAT IS THE PROBLEM. YOU HAVE TO OPEN DEM UP. TAKE OUT THE SCREWS ON THE TOP DEN TAKE OFF THE BLADE. ONCE YOU HAVE THE BLADE OUT ...
...clipper by removing the two Phillips screws. When you lift it away you will see the plate that slides when you move the lever. Beside it are 4 smaller Phillips screws, two on either side. Tighten ...
33 questions posted
Usually answered in minutes!
65 Questions
52 Questions
58 Questions
25 Questions
12 Questions