2002 Ford Taurus "camshaft synchronizer" Questions

...or the camshaft synchronizer (the part that took the place of the distributor on DIS engines) is failing, or if you have recently had the camshaft synchronizer replaced it could be out of

...camshaft synchronizer. The camshaft sensor spins around in this assembly. If it has play in it the sensor will rub on the assembly & cause a squealing noise. It will generaly set check engine ...

Camshaft Synchronizer/Sensor About 58,000 miles on car...check engine light has never turned on...Had chirp/squeak coming from top rear of engine. Determined it was the camshaft synchronizer/sensor. ...

...camshaft gear. When synchronizer flange is fully seated against block, the installation tool should be facing counterclockwise of engine centerline approximately 33 to 45 degrees. Install hold-down ...

...camshaft synchronizer. It is located on the top of the motor on the driver side (back) 0f the engine. Follow the link to see video that tell you all there is to know. How to replace camshaft ...

...code means that shows on the OP2 scanner - p1336 . i have a 2002 ford taurus This code means the camshaft and crankshaft are not synchronized. In general, in old terms, the timing mark on the ...

...on the top of enjine not the belts If is this a 3.0 12 valve. The most likely cause is the camshaft synchronizer. This is located toward the back of the engine, it takes the place of the

...misfire at 1000 R.P.M. I put new wires and plugs and coil pack in it and it still missing fire Have you checked your camshaft sensor? It's possible that the vane on the Synchronizer is

Location of camshaft synchronize on ford Taurus 2000 3.0 24 valves contact the parts store for a printout for timing chain/belt replacement.. it should show a detailed view of the timing marks..

...camshaft synchronizer (the part that took the place of the distributor on DIS engines) has failed, if you have recently had the camshaft synchronizer replaced it could be out of time. P1309 code is ...