2000 Oldsmobile Silhouette "replacing coil pack" Questions

...coil pack on my 2000 Olds Silhouette. I know I have to rotate the engine. But am unsure on how to do it correctly. you do not have to rotate the engine to change the coil packs. just turn the van off ...

...coil pack, spark plugs, but will not start Hi Lamont is fuel getting up is fuel pump ok ?disconnect hose by engine just to test pump but b care ful let fuel collect in jar don't want any fires also ...

...and while driving down the road it sounded like something fell out of the motor and it died. It try to crank but won't fire. We replaced the coil pack but it is still doing the same thing. Please ...

I had problems starting the van I change the ignition coil packs the thermastat it starts but always sound like has no coolant radiator is full service eng.light stays on had it scaned and get a code ...

replacing alternator how to change It's not too bad of a job. First, disconnect the negative battery cable, then push on the belt tensioner with a wrench or a bar or whichever is suitable, then slip ...

...pack and the injectors want pulse. I have replaced the ignition control moduel and the crank sensor, with no luck. Could this be caused by the engine computer, or do you know of something else that ...

1994 silhouette oldsmobile van..Put new fuel filter and coil packs in it turns over but still wont start what else could be the problem? If it will run on starter fluid your ignition is ok and you are

replacing it an that all the connecton are good. Now with that said, There are three thing required to make an engine run. 1-proper air/fuel ratio. proper fuel delivery and pressure. 2-proper cylinder

...coil pack and the canister vent valve which mounts on the back of the coils, getting at these rear bolts is a bear, I wouldn't replace them just put the vent valve on the studs the ignition coil on ...

...coil pack.... cranks over fine just no fire.... also injectors are pulsing with key in on posistion The coil is good after you check resistance from primary and secondary terminals, but it won't ...