Maytag M7DH65B2A Dehumidifier "control thermistor" Questions

Ad

...control Error 6 NTC thermistor damaged/out of position Replace or readjust the thermistor Temperature is too low Temperature should be above -20? Damaged or defective wiring Repair the wiring ...

Ad

Question about Whirlpool Dehumidifiers

3 Answers

...Thermistor and control box on mine (hopeing I just needed a new thermistor which should be available I would think for less than $5 at a electronics supply store) by cutting replacing the thermistor ...

Ad

Question about Maytag Dehumidifiers

2 Answers

...panel control board (the one w/ all the LEDs/controls/7-segment displays on it). It comes w/ all the sensors (including the thermistor). It was ~$38 when I purchased it at RepairClinic.com

Question about Maytag Dehumidifiers

1 Answer

...control issues. RepairClinic.com had a replacement sensor board (included all sensors - yes, the thermistor too...) so I purchased it (~$40) and used only the new thermistor off of it to plug into my ...

Question about Fedders Dehumidifiers

2 Answers

...panel control board (the one w/ all the LEDs/controls/7-segment displays on it). It comes w/ all the sensors (including the thermistor). It was ~$38 when I purchased it at RepairClinic.com

...could be a possible problem with your control panel, thermistor, or a wiring harness. I would recommend contacting your manufacturer for further assistance with your dehumidifier. Best of luck! ...

Question about Kenmore Dehumidifiers

5 Answers

thermistor from the copper tube on the cooling lines; remove the humidity sensor from the front of the evaporator; pull the wire plug off the bucket switch; & remove the small 7 pin plug from the main

Question about Kenmore Dehumidifiers

1 Answer

thermistor or ultimately the control board. I did an ohm reading on the thermistor but I don't know what resistance I should be getting at room temp and some where around 32 degrees.Any one that might

Question about Kenmore Dehumidifiers

1 Answer

...Thermistor PN: 6877A30013R other diagrams it is called a sensor assembly Here is something to consider.... changing this part SHOULD fix the dehumidfier. However, if there is a problem on the control ...

Question about Comfort-Aire Dehumidifiers

1 Answer

...an hour after doing nothing else. Since this temperature sensing is an analog function to the microcontroller that runs everything, the fault could be any bad connection or solder joint along the

Not finding what you are looking for?
Maytag M7DH65B2A Dehumidifier Logo

232 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Maytag Dehumidifiers Experts

Paul Carew

Level 3 Expert

3808 Answers

ADMIN Andrew
ADMIN Andrew

Level 3 Expert

66980 Answers

Larry Ng
Larry Ng

Level 3 Expert

14606 Answers

Are you a Maytag Dehumidifier Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...