Dyson DC07 Bagless Upright Cyclonic Vacuum "remove broken clip" Questions

...Remove the broken clip by gently prying it off with a flat-head screwdriver or a similar tool. Be careful not to damage the surrounding area. Obtain a replacement clip. You may be able to purchase a ...

Remove broken belt Remove roller from it's compartment Install replacement belt (hooking it around the motor and roller, using the roller for leverage to stretch out the belt until you have the roller

...clip removed, how do you ease out the broken unit. a video illustration will be helpful. I can't provide videos, but I can guide you through the process. After removing the clip, gently wiggle and ...

remove this. Instead drill about an 8mm hole through the plastic plate, roughly in the middle level with the large 'A'. This will give you access to the bottom of the clip. Put a flat blade scewdriver

...broken. Is there a way to fix the handle and not have to buy a whole new hose piece that runs about $60+? The clip can be replaced by taking apart the handle. Small round plastic inserts cover up the ...

...the bottom the clips are located close to the corners of the vacuum. after you have these clips removed, press the handle release to rotate the head up a little and the top cover will come off. ...

broken. You don't need a manual for this. Place the handle drive lever in the locked, off position. Remove the 2 screws for the handle them remove the handle, you may have to give it a good knock from

broken brush belt. Unplug the vacuum and turn it upside down. Remove the cover over the brush, sometimes with simple push clips or screws and find the belt. If the belt is there but broken or worn out

...broken, but often the problem is that the axle is sticking and the spring can't do its job properly. Try a small drop of oil under each of the 3 metal tabs. If that doesn't work, remove the 3 tabs ...

...broken. I have replacement but can't get the old wheel off by the picture of the nilfisk a300 replacement wheels its a pull off clip on type design the axle should be metal it will need some force to ...