Kenwood KAC-7202 Car Audio Amplifier "amp issues" Questions

Ad

Question about Hifonics Car Audio & Video

1 Answer

the amp will not turn on it has power but will not come on . i hook it up and it played for a minute then quit Sounds like your amp is going in to protect mode. Had the same issue with my amp. What I ...

Ad

Question about Alpine Car Audio & Video

1 Answer

Alpine MRD-M500 Amplifier my alpine MRD-M500 amplifier, says E-3 and, my subs aren't working. but when i shut off my truck, and turn it back on, my amp is fine and subs work, for about 10 seconds, ...

Ad

Question about Car Audio & Video

1 Answer

my car amp is not working right..... when turning on the car the amp dont stop from throwning bass its just goes boom boom boom boom boom and with no volume on the car stereo Remove the RCA preout ...

mtx thunder 304 4ch red amp light comes on but no audio MTX thunder 304 4ch red amp light comes on but no audio have triple checked all connections and they seem alright if the lights on and there is ...

Question about Rockford Fosgate Car Audio & Video

1 Answer

...issues starting or dimming of the headlights? It's possible your battery is the issue. If the battery is fine, check all of the power connections (including the ground lead of the amp) between the ...

Question about Sony Car Audio & Video

1 Answer

HAVE KIKCER L7 WHEN HOOKED UP TO AMP IT DOESNT DO ANYTHING HOW COME lets do some diagnosis.. if it's possible, try hooking another known good sub up to the amp and see if that works. if it doesnt, ...

amp to a lvl it was used at before with the subs and it worked with no issues, but i purchased it off a good friend as he upgraded and he had no issues with it and i seen it in action. but now it will

Question about Kenwood Car Audio & Video

2 Answers

...bass. i have a cap hooked up so power shouldnt be an issue it is most definately a power issue your amp is cutting out due to over juicing (assuming your amp is solely hooked up to your subs and your ...

I have a 50x2 amp that is bridged 100 into a 4 ohm load. can i run this to a 6x9 3way speaker rated 100rms 4 ohm Yes, you can. There's the impedance match between amp and speaker (4ohm to 4ohm). The ...

Question about Alpine Car Audio & Video

1 Answer

I have an Alpine M500 mono amp that works great, until you turn up the volume. I can adjust the bass down at the head unit, but at higher bass the amp shuts off. And then comes back on after a couple ...

Not finding what you are looking for?
Kenwood KAC-7202 Car Audio Amplifier Logo

90 questions posted

Ask a Question

Usually answered in minutes!

Top Kenwood Car Audio & Video Experts

xxxxxx xxx

Level 3 Expert

5117 Answers

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Cindy Wells

Level 3 Expert

6688 Answers

Are you a Kenwood Car Audio and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...