connection how do i connect this model amp to a pioneer deck? schematic & instructions on deck red (+) - power - 2 amp's power inlet power (+) black (-) - ground - 2 amp's power inlet ground (-) deck ...
amp from it turning off consistently. The amp should be running at 2 ohm stereo stable or 4 ohm mono stable. Very few amps are designed to run at 1 ohm or less. Not to mention the subs can't handle it
Question about Kicker Car Audio & Video
installing the amp with a extra battery and a capacitor i have never had a amp this powerful before and i want to install it myself(im trying to learn the trade for a job)Ive hooked up subs and an amp
...amps inputs. But my head unit has RCA inputs, (sub in & front & rear inputs) so from my 4 channel amp I run 2 6 inch alpine S's to the front to the front RCA inputs of the head unit, & 2 ...
...2 amps. i'm familiar with installing amps just never did 2 in one vehicle before. Ideally you would use 1/0 gauge power and ground wire for the amps, and use power distribution blocks to reduce it to ...
i cant hook up my amp i have 2 12cvr and a zx1000 amp how do i hook them up Hello cesar199064, These are the steps you required to install your amp and subs: 1) Purchase an amp wiring kit with 2 or ...
...amps will work into a 4-ohm or a 2-ohm load with no problems. Going below 2-ohms is bad, because it will cause the amp to overheat and possible fail. Going above 4-ohms is no problem for the amp, but ...
installing two amps I have a 2 channel amp 600 Watts RMS x 2 Channels @ 2 Ohms (Stereo) 300 Watts RMS x 2 Channels @ 4 Ohms (Stereo) and a Alpine 600w rms @ 2 ohms mono amp. I want to push 2 kicker l7
Question about Clarion Car Audio & Video
Installing APX490 in a boat with 4 speakers and 1 subwoofer. The factory manual shows a diagram with each of the 4 wired to an individual channel and the subwoofer - wired to - terminal of the LF ...
I'm using the hi input installation method to add I'm using the hi input installation method to add an amp to my system. The 5 pin connector has a ground 2 white an 2 gray wires but are not marked
25 questions posted
Usually answered in minutes!
114 Questions
80 Questions
69 Questions
73 Questions
63 Questions