Behringer Xenyx 2222fx Premium 22 Input 2/2 Bus Mixer "mixer fuse blown" Questions

...the mixer as the fuse will be inside the mixer on a circuit board (look around inside where the effects part of the mixer is) replace it with an identically rated working fuse and you should be

...fuse in PMP3000. The mixer went out on us one day, so I hooked it into an amp that we had. It works good as an unpowered mixer, but cannot get it to work as a powered mixer. I am assuming a fuse is ...

mixer blew a fusework Any unit that blows fuses needs to be serviced. Do not keep putting in fuses only for them to be blown again. Each time you put in a fuse and it blows, it will create more damage

mixer blew a fuse ,replaced it ,has blown several more fuse's since,i used a lower 5 amp fuse did not last - 10 amp is standard > is it time to trash this unit? I don't understand because the Xenyx

...mixer and friend of mine plug into 240v power point, blown the two transistors ou. I do not know what short of transistors are they? There are dozens of transistors in the unit... we can't guess ...

...mixer that has a blown 1A fuse. What would be the most common cause. The most common cause of a fuse blowing is excess current... now what has/could cause that is impossible for us to diagnose ...

...fuse. If it has blown, do NOT replace it without taking for service first. Additional damage often occurs when users replace fuses that have blown due to internal failures in equipment. Also check ...

...cord.  The light will act as a resetable fuse and will light when there is a short within the mixer, thus absorbing most of the voltage.  Enough current will flow to diagnose the

...mixer for the blown fuse (it'll be near the bit that's not working) and replace with a fuse of the same rating, Faulty button breaks off and no longer contacts the tip switch beneath. I used ...

...mixer into and 220 socket. Is there a fix for this? assuming that its meant for a 110 outlet then you may want to check the internal fuse the high volatge would have blown the fuse before doing any ...