AudioBahn DUB Mag Audio DUB2502 Car Audio Amplifier "mono rca speaker wire" Questions

RCA inputs. The switch to select MONO(R), STEREO, or MONO(L) works as explained. If you want stereo, put the switch in the middle and supply two inputs and two speakers. The MONO(R) and MONO(L) are to

...the front and rear to left/ right? check your deck settings to see that the rear speaker rca are connected. check all wires are connected. push the mono or bridge buttons are off. provide more

...the green set of wires for that say sp-input You could hook up speaker wires from radio directly as it has a converter built in. If you are using an aftermarket radio it has RCA jacks. So not

...mono is still pumping the subs. If the amp done for? I have this same amplifier. I have noticed several ways it will "not work" during my ownership of it. I have it connected to a seperate battery to ...

...mono..i cant get any sound to come out my subs.. The positives are connected together and the negatives are connected together. The two pairs of terminals are for convenience. You'd connect one ...

rca cables and no sound comes out? From Page 7 of your manual... this is indicating a grounded speaker wire (blown voicecoil). It has shut down to prevent damage. Disconnect the speaker wires from the

...mono 1000watt amp I have a 1000 watt amp, after a few seconds of playing it makes like a loud bass noise and it doesnt go away unless i unplugg it. They have told me that it's bcuz it doesnt have ...

wiring power house phd2 mono amp to the earthquake 4 ohm speakers. When i hooked up my bass knob the amp made my subs hum i unhook the rca but still humming unhook bass knob still hummin

...speaker connections and rca cables. Leave power, ground and remote wires intact. Try turning on again. If you still have a protection light your amp is faulty. Hopefully you have warranty I would buy ...

...wiring the amp in mono such as rca r/l or both inputs and speaker wiring. leave rca as it is,only speaker config is needed there should be an illustration printed beside the connectors that says ...