One of the overflow tubes on the right side of my bike came off.

With the engine cool, locate the radiator cap on the right side of the motorcycle under the fake tank (the real tank is under neath a plastic cover). You may have to take off the right lower cowl. Remove the cap and fill the radiator to the top. Now, take off the seat and fill the overflow bottle to the high mark. You can follow the overflow tube from the over flow bottle to the radiator cap and vice versa. Ride the motorcycle and check the over flow tank level again after the bike cools down .

Hi and welcome to FixYa,

Would the wiring of a 95 YZF750 R/SP European model help?

Good luck and thank you for asking FixYa.

The varnish is causing the float inside the carb to stick in an open position. The carbs will need to be removed and cleaned with carb cleaner. Tough varnish can be quickly removed using denatured alcohol.

The Yammy 600 run at high RPM. Also depends on rear tire size

use your key under the left hand side of the seat cowling turn it,lift the back of the seat.

check if the carbs are in sync,check all feul lines and carbs are clean ,are running standard pipe ? if sports pipe you will need to rejet the carbs dont ride the the bike til you have done this ,you run the risk of breaking the engine which will be painfull to you and the bike.good luck

I believe there is no dipstick, but there is a viewing window on the right side (sitting on the bike) next to the oil case. its just a little small around window about the size of a nickle