No it will be clock wise to tighten and anti clock wise the loosen
SOURCE: What kind of oil does my honda shadow 750 aero
As this is a 4 stroke bike, it will take 4 stroke motorbike oil, you can buy this from any good garage
SOURCE: I would like to know how to lower my honda shadow
When lowering bikes, we usually lessen or cut the shock absorbers (front and back).
Accessory places have lowering blocks, they are just a small metal
accessory that move the bottom of the rear shocks to the rear and down,
I think you get 1.5 inches from them. Then you need to cut or get shorter springs in the front, either will probably make the ride stiffer in the front.
SOURCE: how to change rear tire on 2004 750 honda shadow
You do not have to remove the final drive , the wheel is resting on a spline shaft. Center stand the motorcycle or lift the rear wheel, remove the axle bolt, knock out the spacer, and slide the brake panel out of the way. Now the wheel is resting only on a splined shaft. Grab the wheel and gently slide it away from the final drive ( off the splined shaft ) and roll it out the back of the wheel well. When replacing the wheel be sure to get some MOLY60 paste from the Honda dealer and grease the spline before putting the wheel back on.
SOURCE: 2007 honda shadow aero vt750 will not stay running
You probably have some gelled gas in the carbs. Take off the fuel line going into the carbs and spray some carb cleaner directly into the bowls. This may take care of a minor clog. If this does not work , you will have to take the carbs off and clean the slow jets and slow circuit passageways before the bike will idle normally again.
SOURCE: remove rear tire honda shadow
Center stand the bike or jack it up to get the rear wheel off the ground ,loosen the rear axel nut, take out the bolt, knock out the spacer on the brake panel, unhook the brake cable , unbolt the bar going to the brake panel, grab the wheel, and slide it sideways away from the final drive. The wheel should slide right off the spline of the final drive and roll out the back under the fender. If the wheel wont slide past the final drive let the air out of the tire. Be sure to coat the spline of the final drive with moly60 paste from your local Honda dealer when reassembling.
145 views
Usually answered in minutes!
×