2003 Harley Davidson FXDL Dyna Low Rider Logo
A
Anonymous Posted on Aug 28, 2013

I was riding and speedo turned off,engine light came on, bike stayed running, slowed at stop sign lights came back on. Thinking its a loose wiring . Where do I start????

5 Related Answers

goalie39

Ed

  • 479 Answers
  • Posted on Apr 13, 2009

SOURCE: 2006 Screamin Eagle Fat Boy- tach, speedo, blinkers not working

You've blown a fuse, check the fuse block. it should be an accessory fuse.

Ad

Anonymous

  • 420 Answers
  • Posted on May 07, 2009

SOURCE: while riding all lights started to flash engine run erratic bike died of death bike will not start

Start with charging and load testing the battery. Then test the stator, to test the stator on the bottom of the right down tube is the plug that goes from the stator to the voltage regulator. With a multi meter, read the voltage from the stator, I forget the exact values but as you rev the motor the voltage should climb if it dosn't your stator is bad. If the stator is good take a reading again with the motor running at the battery cables, again I forget the exact value but you should have a steady reading at the battery, if it isn't and fluctuates it is bad.

Anonymous

  • 4 Answers
  • Posted on Aug 10, 2009

SOURCE: fuel gauge not woking 2006 fi harley softtail standard

Check your fuses and for possible shorted or cut wiring.

OneRide

Gar

  • 384 Answers
  • Posted on Aug 12, 2009

SOURCE: when I ride my 2000 fatboy my speedometer doesn't

Try inside the tach on the connector. But also remove your speed sensor on the transmission and clean it. They pick up metal chips from the trans and short out. Also, HD had a bunch of bad speedos around your year. They replaced them for free. Doubtful they will replace yours at this late date. You might end up buying a new speedo.

Anonymous

  • 216 Answers
  • Posted on Oct 22, 2009

SOURCE: bike acting up

yea . its electrical.....trace all your wires - look for a shot . wrap your wires

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

2003 polaris 330 won't stay running with lights on

charge system fault
could be the charger ( alternator) voltage regulator or loose wires
indicates not enough power to run the ignition system when the head light is turned on
Nov 25, 2017 • Polaris ATV
0helpful
1answer

YZF R125 Engine Management light on, but engine runs ok.

I had this exact problem with my r125. My speedo just read 0 and warning light came on. This is caused by a faulty speedo cable. You need to unclip it from under the clocks (the white connector running to the side of the front wheel) and take the front wheel off. Then replace the speedo sensor with a "new" one (quite fiddly to put all back together). Got mine off eBay for just a few pounds. When it's all back together, the warning light will still be on, but when you ride off and the speedo reads something other than 0, the light will go off, and problem solved! When your wheel is off, take the time to re lube the axle, makes putting the axle back in so much easier and your front wheel will turn so smoothly and freely. Make sure you keep note of how the spacer goes in, and I'd get a friend to help support the wheel as you put it back in, makes it so much easier as it's quite fiddly by yourself.
0helpful
1answer

Wiring

Sounds like you have linked these up to ignition switch out feed to the kill switch/running curcuit rather than the lighting curcuit out from the ignition. most bike run 2 somtimes 3 curcuits out from the ignition switch one running curcuit and one lighting.
0helpful
2answers

Electrical trouble

If all the fuses turn out good especially the main fuse then you might want to check your starter solenoid. Try jumping the two leads on the solenoid if the bike starts then most likely the solenoid is bad. If it doesn't start then it could be two other things. 1- your Ignitions might be shoot. tell tail signs. Bike cutting out during the ride and bike loses power when you hit the starter button but power returns when you turn the key off then back on. 2- The Rectifier might be gone. The rectifier will cause many different problem that might have you chasing carb problems, to the bike won't start at all with no cranking
Not finding what you are looking for?

193 views

Ask a Question

Usually answered in minutes!

Top Harley Davidson Experts

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Sean Wright
Sean Wright

Level 3 Expert

2045 Answers

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Are you a Harley Davidson Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...