Started car moved it out of the garage onto the drive all fine left for 30min and it would only turn over but not start,all checks done,battery,pump,fuel,plugs,all ok,put a diagnosis tool on and no fault code found local garage did the same with his machine and again no fault codes are showing but won't start,I'm at a loss please help..

Dar

• 2007 Answers
• Posted on May 20, 2009

SOURCE: Loss of power Mitsubishi carisma 1.9 DiD 2002

Change fuel filter.

SOURCE: same as previous person

egr valve stock in open position,replace unit

SOURCE: 2006 dodge grand caravan-car won;t start.

Test at the spark plug if you are getting current there with a cheap spark plug tester, if not, it could be the spark box. ( it used to be an ignition coil on older cars ) double check the computer for codes which may lead to a cam sensor not giving the PCM information.

Reynaldo Andico

• 2431 Answers
• Posted on Jul 12, 2011

SOURCE: Have a 1999 S10 Chev

You have a bad typical connection hence the code, you are mainy going to have to troubleshoot this one on you own Chevy are popular for good looking wire connection and poor contact especially on the coil area just wiggle the connection and have some one crank it and it will start then wiggle it again and it will stall out, 1351 here is the definition Ignition coil high circuit input what this means is your are internaly disconnected you will need a terminal repair on the ignition coil this is a typical failure on the connection

SOURCE: engine check light on while driving, already replace new fuel filter with regulator, clear fault using vw diagnosis tool, after driving several days, the fault occured again with the fault code p0441>

Your EVAP purge valve may be faulty. Also, check the vaccum lines attached to the valve for any signs of wear and tear. Should be located next to the coolant tank.