Question about 2008 Honda CBR 1000 RR

Open Question

2008 Honda CBR 1000 RR will not idle

It turns over but wont fire and stay running without throttle maintenance and the fans run constant in "ignition on position"? Pulled out harness and inspected, no obvious damage, fuses are good and relays switched out with no change at all. Checked stator and rectifier, both tested around 14.43 V at 2,000rpm and 5,000 I'm thinking Harness or cam sensor? Any ideas?

Posted by Anonymous on

Ad

5 Related Answers

alicantecoli

Colin Stickland

  • 22485 Answers

SOURCE: 1995 jeep grand cherokee tranny swap

sorry cant help here on this because although we have a lot of these vehicles here in spain and they appear to be very popular ,cant say i have ever had to change an auto box on one.Engine sensors yes but gearbox?? practicaly bullet proof these engines and transmissions

Posted on May 16, 2009

Ad

Anonymous

  • 7 Answers

SOURCE: my 1996 chevy silverado 1500 4x4 5.0 is running

also check your fuel flow rate u can havegood pressure but not enough flow and make sureu dnt have water in the fuel

Posted on Jun 30, 2009

Ad

Titilayo Sodipe

  • 1428 Answers

SOURCE: i have a 199 chevy

It is so confusing though I had a go at one sometime and it took a whole lot out of us before we realised that it needed a touch from Chevy garage.

Please visit the Chevy Garage it won't cost you much to fix.

Good luck and thanks for using Fixya.

Rate this solution/ suggestion, please.

Posted on Feb 20, 2010

Anonymous

  • 101 Answers

SOURCE: major electrical problem. I've changed all of the

there is a switch on some of them if you get in a finder binder it will cut off the fuel pumps. this switch could have been triggered of has went bad or wires off of it. Good luck...

Posted on Dec 26, 2010

revs135

  • 89 Answers

SOURCE: 1993 toyota camray battery tested okay pulled

if the battery is ok sounds like the main replay or fuse is blown

Posted on Feb 03, 2011

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 40-FAC heater will not ignite and run. The igniter has been replaced. What should I check next?


These models require electrical power to run the blower fan.
When you connect the electrical cord, the fan should turn on, then you should be able to start / ignite the propane. if the fan does not turn on when you connect the power cord, you will not be able to ignite the propane.

Dec 09, 2014 | All-Pro Propane Garage Shop Heaters - All...

2 Answers

2008 Honda Civic si


You can replace the TPS without replacing the whole throttle body.
The TPS is held in by rivets instead of screws. Just use a hacksaw to carefully cut slots in the top of the rivets so you can use a screwdriver to back them out. When you put the new TPS in just use standard screws. Thanks

Oct 30, 2008 | 2007 Honda Civic GX NGV Sedan

1 Answer

I have a 2003 Suzuki TL1000R. It was running fine, then I stopped for gas. When I tried to start it, it would only turn over slowly, but would not fire, and the little F1 light came on. Help??


Open your rear seat and you'll see a black cap covering a connector/harness on the left side of the seat. If you take the cap off, you'll see it appears to be a normal harness. With your key in the ignition and bike turned to "on" (but not running), take a paperclip and short the two connectors out (by touching the two contacts together). This is known as a "ghetto dealer mode switch". It should display the error code on your display instead of just FI now.



Fuel Injection (FI) Code List:

C14 - THROTTLE POSITION SENSOR
C15 - ENGINE COOLANT TEMPERATURE SENSOR
C21 - INTAKE AIR TEMPERATURE SENSOR
C22 - ATMOSPHERIC PRESSURE SENSOR
C23 - TIPOVER SENSOR
C24 - IGNITION SIGNAL #1
C25 - IGNITION SIGNAL #2
C26 - IGNITION SIGNAL #3
C27 - IGNITION SIGNAL #4
C28 - SECONDARY THROTTLE VALVE ACTUATOR
C29 - SECONDARY THROTTLE POSITION SENSOR
C30 - SECONDARY THROTTLE CONTROL UNIT
C31 - GEAR POSITION SENSOR
C32 - INJECTOR SIGNAL #1
C33 - INJECTOR SIGNAL #2
C34 - INJECTOR SIGNAL #3
C35 - INJECTOR SIGNAL #4
C41 - FUEL PUMP CONTROL SYSTEM
C42 - IGNITION SWITCH SIGNAL
C46 - EXHAUST CONTROL VALVE ACTUATOR (1000 ONLY)

Jul 11, 2014 | 2003 Suzuki TL 1000 R

1 Answer

When I turn car off amp still stays on without keys in ignition


the constant power should be run to the battery. The "turn-on power" should be run to your radio which only comes on by the ignition. If it still comes on then your radio is wired to come on without key. Then you have to check the constant and turn-on wires for it.

Dec 19, 2012 | Orion HCCA-D2400 Car Audio Amplifier

Not finding what you are looking for?
2008 Honda CBR 1000 RR Logo

Related Topics:

292 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

Arnie Burke
Arnie Burke

Level 3 Expert

6480 Answers

Marvin
Marvin

Level 3 Expert

85239 Answers

Gino Cussen
Gino Cussen

Level 2 Expert

217 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...