2001 Suzuki DR-Z 250 Logo

Related Topics:

Posted on Mar 09, 2009

My dr 250 1984 has low compression

My dr 250 suzuki 1984 has low compression starts for about 20 seconds then dies it all started when the acelorator got stuck on one morning and the bike reeved flat out

  • Anonymous Mar 17, 2014

    Compression lt 250 fwd suzuki

×

1 Answer

Anonymous

Level 1:

An expert who has achieved level 1.

Problem Solver:

An expert who has answered 5 questions.

  • Contributor 7 Answers
  • Posted on Mar 09, 2009
Anonymous
Contributor
Level 1:

An expert who has achieved level 1.

Problem Solver:

An expert who has answered 5 questions.

Joined: Mar 09, 2009
Answers
7
Questions
1
Helped
2622
Points
8

Your carb got stuck and it sounds like your rings are burnt out like u were running to high of an octane or something in your gas

  • Anonymous Mar 09, 2009

    your carb got stuck and it sounds like your rings are burnt out like u were running to high of an octane or something in your gas

  • Anonymous Mar 09, 2009

    your carb got stuck and it sounds like your rings are burnt out like u were running to high of an octane or something in your gas

×

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Will not start 2003 Suzuki DR-Z 125 L

Have u checked the timing it could have jumped time and warped the valves that could b why you have low compression to check valve take plug out take carb and exhaust off make sure valve is closed on intake poor gas in the valve if it leeks out bad valve if it dont good valve repeat on exhaust valve hope this helps u
0helpful
1answer

2006 drz 400 will not start right up and once started sometimes it tries to shut off while riding

motor may have low compression or the carb has dirt in the jets or floats are messed up my guess is floats
0helpful
1answer
0helpful
1answer

I have a 1987 Suzuki Dr 600 r Dakar, Was riding wh...

probly blew engine but a top end is not hard to do with a clymer manual-theyr detailed and will make u a pro like us
May 19, 2010 • Motorcycles
1helpful
1answer

What should the compression be on a 2004 Suzuki DRZ 125?

With the throttle held wide open, the compression should be between 140 psi and 180 psi. If the compression reads lower that 140 psi, adjust the valve tappet clearances and try again. Insufficient valve tappet clearance is the most common cause of low compression in four stroke engines.
1helpful
1answer

Suzuki gn125 wont start. checked carb, cdi, coil. got compression and spark but it wont fire. timing been checked. i have ran out of ideas.

Check the valve adjustment. If a valve is standing open just a little, the compression will be too low to start the engine. Check fuel delivery by dribbling a little gasoline into the carb and try starting the bike. If it starts and runs for a second or two, you're not getting fuel into the cylinders. Check you carb again.
2helpful
3answers

2002 Suzuki DR 650

Small oil leak at the top of motor
0helpful
1answer

Motor won't start afte being parked

firstly check for ill fitting exhaust ie /gasket (2) check timing /3valve seating/4piston rings barrel wear /will update shortly
Not finding what you are looking for?

813 views

Ask a Question

Usually answered in minutes!

Top Suzuki Experts

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Sean Wright
Sean Wright

Level 3 Expert

2045 Answers

Bob G

Level 2 Expert

104 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...