Where do you look in order to find the crank sensor?
Crank sensors measure the reluctor wheel at the crankshaft of the engine, so look between the engine and the transmission down in the hood area. Look for wires going to it.
SOURCE: location/testing of crank sensor 1995 jeep wrangler
Should be on the bellhousing on the drivers side just where you need rubber arms to reach it.Should have no continuity between b&c terminals (check with ohmeter) Harness plug is usually on the drivers side between the master cyl and the back of the engine (unless someone moved it)
SOURCE: jeep wrangelr Crank Position Sensor
wall5552: there were two engines used in 1992 Jeep Wranglers.
A 2.5 liter and a 4.0 liter. HOWEVER>>>> The location for the crank angle sensor is the same for both.
It is located on the bell housing up near the front at about the 10:00 PM position.
The Cam position sensor is located in the Distributor on both engines as well.
456 views
Usually answered in minutes!
×