HOW DO YOU GET TO THE PLUGS BETWEEN THE FIRE WALL AND ENGINE ON A CUTLASS CIERA 1990

1995 Oldsmobile Cutlass Ciera 3.1 liter V-6 VIN "M"




1995 Oldsmobile Cutlass Ciera 2.2 liter L4 VIN "4"




Hope this helps (remember to rate and comment this answer).

Disconnect the engine torque mount on the top front , then you can pull the engine forward enough to reach the rear plugs

The thermostat should be just off of the engine. Just follow the main rad hose from the radiator. Post if you need more.

Run a compression test. then check for coils and ignition module.

sounds like an ignition module

CRANKSHAFT POSITION SENSOR

Fig. 8 Ignition Coil Module Assy 2.5L/4-151 The Crankshaft Position Sensor is mounted remotely on the bottom side of the ignition module.

RH Side Of Engine.

Front RH Side Of Engine

Applicable to: Cutlass Ciera & Cutlass Cruiser w/V6-231/3.3L

you will have to un bolt the front engine mount raise the engine and then you may be able to get to the pan bolts but if you're not mecanically inclined you need to consult your nearest dealership

Fuel filter or pump. Get the pressure checked

replace crank sensor. It gets hot and stops working.

the easy way to find this is to fallow your bottom raditor hose to the engine where it attaches is called the thermostat housing remove the hose and remove the four bolts then take out the thermostat replace it and re install don't for get your antifreez you will need to replace it do to the loss when you remove the hose