P0705 Transmission range sensor circuit malfunction code for a 1997 Mitsubishi Galant tranny shifts with hesitation can I replace a sensor and where is it located?

BMW transmission range sensor position Vehicle Parts ...

www.fixya.com/tags/transmission_range_sensor_position/auto.../bmw

BMW vehicle parts & accessories transmission range sensor position related ... i got a transmission fault warninig my bmw car 545i E60 it is a 2004 E60 bmw car ...location transmission dipstick 1997 bmw 328is if its a manuel transmission it ...

P0705 Transmission Range Sensor TRS Circuit Malfunction

www.obd-codes.com/p0705

Transmission Range Sensor Circuit Malfunction (PRNDL input) ... Later models with the transmission range sensor located in the valve body are a different ball ... What causes the P0705 code on a BMW 740i ('97) ... 2004-2015 OBD-Codes.com.Missing: 545

code p0705 refers to transmission range(TR) sensor/switch--PRNDL input--circuit malfunction===causes--wiring---TR sensor/switch---ECM/TCM

either fit a manual gearbox or change the control computer for the autobox,no work then do what i did and buy a old van and do kerbside mechanics better than nothing , i know when its raining and cold but at least you will earn a living and buy your spares from a autofactor and not a corner shop

it is your neutral safety switch that needs to be replaced

P0705 = transmission range sensor, circuit malfunction (PRNDL) input.

Check the shift linkage/cable to the transmission. Check the transmission range switch/sensor.

P0705 - Transmission Range Sensor Malfunction. The park/neutral position (PNP) switch includes a transmission range switch. The transmission range switch detects the selector lever position when the shift lever is in the N or P shift position and sends a signal to the Transmission Control Module (TCM). The possible causes of this are the following: Open or short park/neutral position switch circuit. Poor park/neutral position switch circuit connection. Misadjusted park/neutral position switch. Park/neutral position switch may be faulty. Inspect the pnp switch and replace if needed.

OBD Code P1750 = Solenoid Assembly / Manufacturer Control Transmission.

I tell you it is infact your solenoid box assemble is going. What that does is to tell your transmission when to shift into gears. Im assuming your car is having a hard time shifting gears and juts need replace this part.


OBD Code P0705 = Transmission Range Sensor circuit (PRNDL - Input).

I'll check the Neutral Safety Switch. It's located on the shift shaft of the trans, and is a common problem. Also check the wiring leading to the switch, as it is exposed to road grime and has been known to corrode and melt.

Also can review this DTC P0705.

Hope helps.

Usually a P0705 means your TRS (transmission range sensor) is shot. It is what looks like an old backup light/neutral safety switch and is attached to the transmission where the shift lever goes in. .

P1243 - Inquiry Response Error - try reading codes again.
P0725 - Engine Speed Circuit Sensor Malfunction. - VSS or wiring bad.
P0705 - Transmission Range Sensor Circuit malfunction (PRNDL Input) - Sensor or wiring bad.


Thanks for using FixYa - a FixYa rating is appreciated for answering your FREE question.

P0705....Transmission Range Sensor Circuit Malfunction (PRNDL Input) . probably means that that a plug may have come off or a wire got cut thus the circuit to the Park , Reverse, nuetral , Drive or Low had a "malfuntion". Ot it couldbe the sensor itself on the tranny.