SOURCE: i have two warning lights on they are esp light
The eps light is related to your brake light sensor. The emission light you will need to have the code read. Go to your local auto parts store and have it read.
SOURCE: golf gt tdi 2.0 140 bhp mk 5 - esp light
When there's something wrong with the brake pressure that handbrake warning light comes on.
The ESP warning light could be caused by a lot of things, but most likely it's a dirty fuel filter. Don't take my word for it though, just go to the VW dealer and have it read the faultcodes from the ECU, which should point you/them in the right direction.
Alternatively, when you have the right equipment (= VAGCOM + cable) and knowledge, you or a friend yould diagnose the ECU yourself.
From the sounds of it, you'll need a small service (air filter and oil filter change, etc.) anyways. Don't forget to reset the ECU (or dis- and reconnect the battery) afterwards to erase the faultcode from memory (when there's still something wrong, it'll return soon enough).
You might get lucky with a small service :)
SOURCE: on my passat ESP warning is coming on. i have
You should have the OBD codes checked. This will determine the exact
fault. The ESP light will sometimes come on if there is a problem with
the ABS or with the steering angle sensor.
Good luck with this
John
SOURCE: 2003 Jetta 1.9 TDI When replacing battery do I
No, the computer will reset itself once the new battery is installed.
SOURCE: the esp light went on
Check & replace if necessary the brake pedal switch placed above pedals on the support.
If the problem still occurs you might access the ABS & ESP ECU (Electronic Control Unit) using diagnostic equipment connected to the data link connector of the car, in order to pull out all DTC (Diagnostic Trouble Codes) memored.
Then you will be able to replace bad piece(s) and fix the problem by erasing all DTC stocked inside ABS ECU & reset it.
The ESP system means the Electronic Stability Program. If the ESP lights on the dashboard permanently the ESP system is faulty. You must access the ESP Electronic Control Unit (ECU) memory for pull out all DTC (Diagnostic Trouble Codes), using diagnostic equipment connected to the data link connector of the car. Then you will be full informed about bad pieces (e.g.: brake pedal switch, front right wheel abs sensor interrupted, ...). After bad pieces replacement you will be able to erase all faults memored by ESP ECU, in other words reset the ESP system and turn off the warning lamp on dashboard.
I'm convinced that your brake pedal switch is faulty because the glow plug warning sign went ON after ESP warning light. Just replace the brake pedal switch, see if rear stop lamps light when press the brake pedal, and test the car on the road.
Good Luck!
187 views
Usually answered in minutes!
×