SOURCE: horn is not working on my 1997 chevy cavalier
should be under the hood in engine compartment. have you checked the fuse?
SOURCE: location of horn on 1997 dodge caravan
the horn is in the fender on the drive side '' and in some molds right in frount of the radater look thourgh your frount grel and you should find it thanks''' my name is james you can e-mail me at '' [email protected].
SOURCE: location of transmission (automatic) dipstick
You DO NOT have one.
There is a small bolt/plug in the transmission above the pan that needs to be removed. The fluid will run out if it's overfilled. The transmission needs to be at room temperature or a little warmer to check the level.
The fluid level screw is intended to be used for diagnosing a transaxle fluid leak or resetting the transaxle fluid level after service that involves a loss of fluid.
Inspect:
The fluid level should be checked when the transaxle is near Room temperature or at 40°C (104°F).
CAUTION: Removal of the fluid level screw when the transaxle fluid is hot may cause injury. Use care to avoid contact of transaxle fluid to exhaust pipe.
The engine must be running when the transaxle fluid level screw is removed, or excessive fluid loss will occur. Since the actual fluid level is unknown, stand clear when removing the fluid level screw. Have a container ready to capture any lost fluid.
WARNING: Do not turn the engine off with the fluid level screw removed as you can be injured by hot transaxle fluid being expelled out of the fluid check hole.
Adding Transaxle Fluid:
SOURCE: need location of thermostat on a 2005 chevy
follow the top radiator hose to the engine, this hose will end at the waterneck,inside the waterneck is where the thermostat is located, be sure to put a new waterneck gasket on when reassembling, also be sure to put the thermostat in with the spring side down, hope this helps
SOURCE: where is the computer fuse
If you are wanting to pull the fuse to reset any codes, the main fuse is located at the battery in what is called a fuse-able link. This is really just a wire of a set size that will burn into at a pre-determined amp rating. If you want to reset codes disconnect both battery cables for about 10 minutes. .
24 views
Usually answered in minutes!
×