If the key fob has stopped working - then the key fob needs a new battery. SmartKey Battery Replacement
SOURCE: key fob not working after battery change ford focus 2006
Try reprogramming it.
1. Turn the ignition from OFF to RUN 4 times within 6 seconds.
2. Turn the ignition OFF. The system will chime to confirm programming mode.
3. Within 20 seconds, press any button on first keyless remote.
The system will chime once to confirm programming.
4. Within 20 seconds, press any button on second keyless remote.
System will chime once to confirm programming.
5. Turn ignition to RUN to exit programming mode.
SOURCE: How do I reset a Key Fob for my 2006 Grand Prix
No Tools Required
In the event that a transmitter is lost,
program the old and the new transmitters into the memory of the remote
control door lock receiver. Up to 4 transmitters may be programmed.
Important
Once the keyless entry receiver enters the
programming/diagnostic mode, the programming of the first transmitter
erases all previous transmitter programming information. You must then
program all of the transmitters.
Program only 1 vehicle remote control door lock receiver at a
time. If you program multiple receivers simultaneously, the same
transmitter could possibly be programmed to more than 1 remote control
door lock receiver.
Perform the following steps:
Sit in the vehicle driver's seat. (actually it’s much ezr from the front pass seat)
Remove the ignition key from the ignition lock cylinder.
Close all of the vehicle's doors.
Remove the MALL PGM fuse from the fuse panel. Refer to Electronic Diagnosis in Body and Chassis.
Turn the ignition lock cylinder to the ACC position.
Turn the ignition lock cylinder OFF, then back to ACC within 1 second.
Open
and then close any vehicle door. You will hear a chime when the remote
control door lock receiver enters the programming/diagnostic mode. If
you do not hear a chime, start again at step 1.
Important
After 7 seconds, you may hear a chime confirming
successful synchronization. After approximately 14 seconds, you will
hear a chime confirming successful programming.
Press and hold the transmitter LOCK and UNLOCK buttons simultaneously for 14 seconds.
Repeat step 8 in order to program each additional transmitter.
Remove the ignition key from the ignition lock cylinder.
Install the MALL PGM fuse back into the fuse panel. Refer to Electrical Diagnosis in Body and Chassis.
Validate that all the transmitters that were programmed operate properly. Refer to Keyless Entry System Operation
SOURCE: my 2006 cadillac sts key fob all of a sudden is
Check the fob battery you might need to replace it, The battery only has about a 3 year life
SOURCE: The key fob for my
The key fobs stop working because the solder joints that hold the battery in place break free. Very easy to fix with a little solder and a soldering iron. I just fixed a bunch of them for people I know including BOTH of the fobs for our 2006 GP GT. Takes about 5 minutes each.
SOURCE: 2006 sienna ce, passenger and both sliding doors won't unlock with key or fob
Can be issue with the switch. http://repairhelpcenter.blogspot.in/2012/02/front-door-dis-assembly-diagram-for.html ------ http://repairhelpcenter.blogspot.in/2012/02/rear-door-dis-assembly-diagram-for.html ------- Repairing car Door lock Actuator?
Help links are provided below for detailed procedure,Click the link below:---
Front Door dis-assembly diagram for Toyota car?
Rear Door dis-assembly diagram for Toyota car?
How to test Power door locks?
http://repairhelpcenter.blogspot.in/2012/02/how-to-test-power-door-locks.html
----------
right side slide door light switch on Toyota
Sienna?
http://repairhelpcenter.blogspot.com/2012/01/details-for-replacing-right-side-slide.html
------------
Door locks not working?
http://technoanswers.blogspot.com/2012/01/door-locks-not-working-on-ford-explorer.html
--------------
Power door locks not working?
http://schematicsdiagram.blogspot.com/2011/12/power-door-locks-not-working.html
--------
http://howtobyme.blogspot.com/2011/11/repairing-car-door-lock-actuator.html
How to Access car door panel?
http://howtobyme.blogspot.com/2011/11/how-to-access-car-door-panel.html
Vehicle door panel components?
http://howtobyme.blogspot.com/2011/11/vehicle-door-panel-components.html
----------
This will help.
Thanks.
461 views
Usually answered in minutes!
×