Crysler 200-2011 the abs light came on & at the same time the cruise control stopped working! What is the problem?
SOURCE: 1995 Civic Timing belt replaced, cruise control stopped working
when the belt was replaced someone probably didnt reconnect something check all connections and fuses
SOURCE: Cruise control,and radio controls on steering wheel, now air bag
The problem is the coiled ribbon contact under the steering wheel (we call it the clock-spring contact) that connects the stereing wheel controls to the steering column wiring harness, this is a printed circuit that is coiled to allow the wheel to move and still have a psychical contact for the wheel switch's and the airbag, anyway replace that contact coil, u must disarm the airbag to do this repair, follow the factory procedure to do this or serious injury can result if the airbag fires.
SOURCE: airbag light comes on, horn and cruise control won't work
these vans are known to have faulty clock springs, which can cause the problems. I think there's a recall on them...give your local Chrysler dealer a call.
SOURCE: Engine light and ABS traction control light remain
The ABS sensor is a speed sensor also for Traction Control. This is why both lights are on , One of your front ABS sensors are bad or disconnected, or has a pinched wire.
SOURCE: volvo s80 1999 2.9 abs stc trac not working
having the same problem with my 1999 s80 2.9 . replaced the abs module twice and still get the brake failure warning. when the ignition key is turned there is a clicking sound from the center console beneath the shifter, then the brake failure warning, and the car will not start. (also after the last abs module replacement the car sometimes gets stuck in park).
742 views
Usually answered in minutes!
×