20 Most Recent
Questions & Answers
Low beam headlight adjustment on 2011 Chrysler 200
How to Adjust Car Headlights Level your car. Start by removing any excess weight from the trunk of the car. Also, ensure that the tire pressure in all tires is at the manufacturer's recommended levels. If possible, have somebody sit in the driver's seat, and that the gas tank is half-full. As well as this, check that your headlight aim adjustment wheel (if fitted) is at the zero position. Position your car. On level ground, park 10 to 15 feet (3.0 to 4.6 m) from a dark wall or garage door, with the front of the car aimed at the wall. A paved parking lot or level driveway is best Turn the headlights on. Do not use your high beams or fog lights. Mark the horizontal and vertical center lines of the headlight beams with masking tape to make two T's on the wall or garage door.Make sure the lights are level. Place a carpenter's level between the two marked center lines to see if they are even. If they are not even, use a tape measure to measure how far up the wall the lower mark is and lower the other center line marker to the same height. These center lines should be no higher than 3.5 feet (1.1 m) from the ground.Back your car exactly 25 feet (7.6 m) from the wall or garage door. Don't estimate the distance! Use a tape measure to make sure you are the proper distance away from the wall. Turn off the headlights. Remove the trim ring from around the headlights and locate the adjusting screws. These screws are typically found adjacent to the headlight, though some manufacturers put the screws in the engine compartment, behind the the headlights. The horizontal adjuster and the vertical adjuster should be marked.
- Always defer to the specs in the owner's manual-Adjust each headlight separately. Block one with a sweatshirt or other object while adjusting and testing the other, since the light-bleed can make it difficult to distinguish one from the other. Have a helper sit in the driver's seat while you do the adjustments, to turn the lights on and off while you make the proper adjustments
on Sep 30, 2016
Chrysler 200 convertable how to put pictures on radio
Sirius Satellite RadioMy Account. I'm a Subscriber ... Image 1 SiriusXM Connect Vehicle Tuner · Image 2 ... Add Satellite Radio to any SiriusXM-Ready™ car stereo receiver. Connect ...
Sirius Satellite RadioThe XM SkyDock incorporates an XM Satellite Radio Tun- er . A special .... image to match the XM SkyDock's .... found on the My Account screen (in Settings), ... Button: Tap to tag the current song and add it to your tagged song list . For.
on Dec 10, 2015
How do I replace a headlamp?
Follow these steps to change the headlight bulb on your vehicle:
www.dmv.org > how-to-guides > headlight
- Open the engine compartment hood.
- Locate the back of the headlight to determine the lamp and bulb type.
- Decide which bulb you need to replace.
- Purchase the correct bulb for your headlamp.
on Dec 04, 2015
Easy way to change headlight bulb on 2011 chysler 200.
Open the hood. Look at the back of the head light assembly. You will have one of two set ups. At the back the assembly will have either two bolts at the top the frame underneath it. Remove the bolts and pull it straight out. Plugs hold it in after that. Or looking at the back again, you will see two metal tabs that have to be pulled up, then pull out on the assembly. The entire lens has to come out of the front to replace bulbs. Just a note, look at the plugs and check for corrosion. Clean them with battery terminal cleaner.
on Mar 26, 2015
Not finding what you are looking for?