Peugeot 207cc fuel filler cover

SPECULATION only... because Peugeots were not
commercially imported to the USA in 2008... BUT

TYPICALLY you must empty & drop the
"GAS TANK" to access the sender unit
(fuel - pump)...

It is a big enough job where it is certainly reasonable
to lift your rear mats to LOOK & see if access is available
(through the car floor) with the FUEL TANK in place...

http://www.mister-auto.co.uk/en/sender-unit-fuel-tank/peugeot-207-wa-wc-1-6-hdi-90hp_v19352_g605.html

I did check a Peugeot FORUM and an UNANSWERED
question remains...

Does any one know how to remove the BIG NUT that
holds the fuel sender in place??
207 fuel sender removal Peugeot 307 forum Peugeot Central

My guess = BIG WRENCH (spanner)...
Sadly I have found no AMERICAN companies
that list significant PEUGEOT parts or tools from
1991 to 2009...

Hope this helps.

My suggestion would be to check the gage FIRST.

Carnac the Magnificent

I have changed my coolant temp sensor but my 207cc still reads hot so im going to need to change the thermostat housing

Hi Carol ! Check your Catalytic converter. Might blogged. If so you surely using too much fuel and not enough power. If is that surely must immediately renew the cat.
Good Luck.

they stick like regular ,get a pair of grips and turn it anticlockwise and i promise it will come off ,happens all the time whenever i service a citreon or a peugeot ,and a ford as they all use the same engine (diesel)

is this the body work cover or the cap that goes to fuel filler cap if its the body one there is a small wire poll that keeps this shut or a plastic clip go into boot where the inside of the filler cap goes into boot pull back the covers and the mecanisim to work this shold be there should be able to open it by hand not sure on model as from uk but most cars are built the same ish hope this helps ivan ps if it just the filler cap use a pair of mould grips to turn it

P0455 - Evaporative Emission Control System Leak Detected (Large Leak). Possible causes - Missing Fuel cap
- Incorrect fuel filler cap used
- Fuel filler cap remains open or fails to close
- Foreign matter caught in fuel filler cap
- Incorrect fuel tank vacuum relief valve
- Leak is in line between intake m

Possible solution - Retighten or replace fuel tank filler cap
- Replaced damage or leaking EVAP canister

Toyota P0441 - Evaporative Emission Control System Incorrect Purge Flow

Possible Causes:
- Missing Fuel cap
- Incorrect fuel filler cap used
- Fuel filler cap remains open or fails to close
- Foreign matter caught in fuel filler cap
- Incorrect fuel tank vacuum relief valve

Possible Solution:
- Retight or replaced fuel tank filler cap
- Replaced damage or leaking EVAP canister

P0441 - Evaporative Emissions Control System Incorrect Purge Flow

Possible Causes:
- Missing Fuel cap
- Incorrect fuel filler cap used
- Fuel filler cap remains open or fails to close
- Foreign matter caught in fuel filler cap
- Incorrect fuel tank vacuum relief valve

Solutions:
- Retight or replaced fuel tank filler cap
- Replaced damage or leaking EVAP canister

Possible coolant in engine oil.Also Check Engine Coolant for cross contamination.