Seat belts locked retracted, SRS light is on

You have a module that's going bad or is bad. Someone had either wrecked the car previously and didn't replace all damages modules. You can have a shop put on computer to tell you exactly which one needs replaced. There is one on the front of the vehicle one under drivers seat and one in with the seat belts those ate just sensors the actual modules are the site bags themselves

When you sit in the seat and put the seat belt on does everything work ok . If so look to the fact that you are required to wear a seat belt and the fact that you are not might be the problem.

To reset the SRS light on an Acura Integra, pull down the SRS service connector. Unplug this connector so you have access to jump the harness. Start with the ignition OFF. Jump the SRS plug. Turn the ignition ON. The SRS light will come on then off.------------------------------------------------------------------------------
autel maxidas ds708

that means there is a situation and probably a diagnostic code stored in your safety restraint system, or air bags this light usually comes on because the thing called the seat belt pre-tensioner is faulty,likely cause that i have found most

SRS is for "Supplemental Restraint System". This includes airbags and any other passive restraint device like a seat belt pre-tensioner. It is trying to tell you that your restraints will not function properly in the event of a collision.

Here's a quick check list for most common cost of SRS / Air bag problem.


Dirty contacts on driver and passenger seat belt buckles

Dirty contacts on seat belt connectors (under seats)

Dirty contacts on driver and passenger sides weight sensors (under seat)

Seat covers

Weight on passenger seat

(Example: grocery package trigger SRS / Air Bag light on the way home.)

I recommend you to pass an vacuum over the contacts and use CRC electronic parts cleaner to rule out connectivity problem.

I DO NOT disconnecting the negative battery connector to clean the code(s)

Without the code(s) the dealer will takes "BILLABLE" time to reproduce the problem.

======

Please rate my answer if it is useful to you.


Cheers,

Mustgo

Yes a scan must be done and it will not cost much.

Though you can drive around with the seat belt but it is not too safe.

See the dealer please.

Here's a quick check list for most common cost of SRS / Air bag problem.

Dirty contacts on driver and passenger seat belt buckles

Dirty contacts on seat belt connectors (under seats)

Dirty contacts on driver and passenger sides weight sensors (under seat)

Seat covers

Weight on passenger seat
(Example: grocery package trigger SRS / Air Bag light on the way home.)

I recommend you to pass an vacuum over the contacts and use CRC electronic parts cleaner to rule out connectivity problem.

I DO NOT recommend disconnecting the negative battery connector to clean the code(s).

Without the code(s) the dealer will takes "BILLABLE" time to reproduce the problem.

======

Please rate my answer if it is useful to you.

Cheers,

Mustgo

there should be a belt diagram from a label either on underside of hood or on radiator support. That should help if you can do it yourself.

The buckle and belt need to be replaced.  They are only good for one time during a collision.  The buckle has an explosive charge in it that causes the buckle to pull back toward the seat.  The belt does the the same.  It locks up during an accident, also so body shops can't try to reuse it.  The SRS light will stay on until they are replaced.