Question about Cars & Trucks

1 Answer

Toyota Echo 2003 SRS light with ABS light blinking instead of Seat Belt Light

When seat belt is not worn seat belt light starts blinking. That's OK. But sometimes this blinking is replaced with SRS and ABS lights. These two lights start blinking and Seat Belt light is OFF. This is intermittent. Some times the seat belt light starts blinking and some times SRS and ABS (both together) lights start blinking instead of Seat Belt light. Where to look for problem?

Posted by Usman on

Ad

1 Answer

Bill Boyd

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Cars & Trucks Master
  • 53,816 Answers

When you sit in the seat and put the seat belt on does everything work ok . If so look to the fact that you are required to wear a seat belt and the fact that you are not might be the problem.

Posted on Mar 09, 2014

Ad

5 Related Answers

Landyman

Karl Molich

  • 89 Answers

SOURCE: After Starting my 1998 Range Rover HSE

If you have oxygen sensors fitted to the vehicle (wires coming from front of exhaust)then the fuel could be causing the engine light to come on.SRS light is probably caused by your seat belt catch not working , you could maybe find a good used part at a breakers yard.Check that the wires are o.k before buying.

Posted on Dec 03, 2008

Ad

Anonymous

  • 100 Answers

SOURCE: 1995 Jeep Grand Cherokee seat belt noise and light.

Hi
There is a switch in the seat belt latch whe your sitting in the seat this will ba the part o the right side, see if something went into the latch part? or the switch is bad i think you have to replace the belt to fix the switch
RD

Posted on Jan 19, 2009

lastech

manuel domingo

  • 408 Answers

SOURCE: srs light come on

hi,send your car to dealer to scan the problem,maybe erase fault is require ,or you can found the exact defective part,ty

Posted on Mar 25, 2009

Håkan Sterner

  • 74 Answers

SOURCE: seat belts locked retracted, SRS light is on

The SRS system involves explosive devices, for some reason they seem to have been set off in your case. Maybe I minor collision or a crash sensor malfunction caused it.

Only qualified professionals may work with these systems, diagnosing and replacing components. This is one of the things that are definitely off limits for DIY-ers.

Posted on May 28, 2009

Anonymous

  • 154 Answers

SOURCE: I have a 2003 Toyota Camry. The driver's side

check the seat belt reciever, sometimes the wiring brakes while noving the seat.. if so e-mail back

Posted on Sep 25, 2009

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

What does the red symbol like a driver with a ball in front of him means on the dashboard


This is a air bag fault light .it comes on when you have a fault in the air bag system.

Feb 19, 2017 | Cars & Trucks

1 Answer

Airbag light on


Tacoma have pressure sensor built in the passenger seat. If you have bags on the seat SRS computer will require the seat belt to be on .sometimes people dropped stuff unger the seat and the SRS wire is disconnected. If nothing visible. Let technician scan the SRS system for coge

Mar 30, 2014 | 2010 Toyota Tacoma

1 Answer

How do i deactivate srs so i can replace front seatbelts on 2005 yaris


Disconnect the battery negative terminal.
1. Wait at least 90 seconds after the ignition switch is
turned off and the negative (-) terminal cable is
disconnected from the battery before starting the
operation.
(The SRS is equipped with a back-up power source, so
if work is started within 90 seconds of disconnecting
the negative (-) terminal cable of the battery, the SRS
may be deployed).
2. Do not directly expose the steering pad, front
passenger airbag assembly, center airbag sensor
assembly, front airbag sensor, front seat inner belt
assembly, seat position sensor, occupant
classification ECU, front seat side airbag assembly,
side airbag sensor, curtain shield airbag assembly,
rear airbag sensor or front seat outer belt assembly to
hot air or flames.

Feb 26, 2013 | 2005 Toyota Yaris 1.3

1 Answer

Reset srs light after replacing seatbelt


To reset the SRS light on an Acura Integra, pull down the SRS service connector. Unplug this connector so you have access to jump the harness. Start with the ignition OFF. Jump the SRS plug. Turn the ignition ON. The SRS light will come on then off.------------------------------------------------------------------------------
autel maxidas ds708

Jan 14, 2013 | 2007 Ford Explorer Sport Trac

2 Answers

SRS Light on? How can I turn it off?


turn off the passenger air bag, is there a check engine light

Dec 15, 2009 | 2003 Honda CR-V

2 Answers

Srs warning light on


Here's a quick check list for most common cost of SRS / Air bag problem.


Dirty contacts on driver and passenger seat belt buckles

Dirty contacts on seat belt connectors (under seats)

Dirty contacts on driver and passenger sides weight sensors (under seat)

Seat covers

Weight on passenger seat

(Example: grocery package trigger SRS / Air Bag light on the way home.)

I recommend you to pass an vacuum over the contacts and use CRC electronic parts cleaner to rule out connectivity2_bing.gif problem.

I DO NOT disconnecting the negative battery connector to clean the code(s)

Without the code(s) the dealer will takes "BILLABLE" time to reproduce the problem.

======

Please rate my answer if it is useful to you.


Cheers,

Mustgo

Oct 08, 2009 | 2007 Toyota Yaris

2 Answers

Endeaver srs light is on after replacing battery how can I reset also the passenger seatbelt light stays on


The light is on because the SRS computer detected excessively low voltage, likely right before your battery failed/was replaced.
To clear the light you will need to take it to a dealer or a repair shop with a Mitsubishi-compatible SRS scantool.

This happens so frequently, I never charge customers for clearing SRS lights that are related to battery changes (code will be IG low voltage A and B).


Oct 03, 2009 | 2006 Mitsubishi Endeavor

2 Answers

Intermittent SRS light 1990 190e 2.6


Check the seat belt wiring under your front seats, seat belt pre tensioners are related to the srs system and sometimes with seat adjustment these can become loose. The wires are mostly yellow in colour and if you check all connections are tight this may solve your problem

Oct 01, 2009 | 1990 Mercedes-Benz E-Class

2 Answers

2005 srs warning light is always on


Here's a quick check list for most common cost of SRS / Air bag problem.

Dirty contacts on driver and passenger seat belt buckles

Dirty contacts on seat belt connectors (under seats)

Dirty contacts on driver and passenger sides weight sensors (under seat)

Seat covers

Weight on passenger seat
(Example: grocery package trigger SRS / Air Bag light on the way home.)

I recommend you to pass an vacuum over the contacts and use CRC electronic parts cleaner to rule out connectivity problem.

I DO NOT recommend disconnecting the negative battery connector to clean the code(s).

Without the code(s) the dealer will takes "BILLABLE" time to reproduce the problem.

======

Please rate my answer if it is useful to you.

Cheers,

Mustgo

May 21, 2009 | 2008 Toyota Prius

2 Answers

Srs light come on


hi,send your car to dealer to scan the problem,maybe erase fault is require ,or you can found the exact defective part,ty

Mar 23, 2009 | 2002 Mercedes-Benz C-Class

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

210 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

john h

Level 3 Expert

23438 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...