Location of a oil sending unit 1996 ford 3.8liter 6cly

the sender unit is located in the engine block close to the oil filter , it has the appearance of a bolt head with wires protruding from it

There is a sending unit that is probably bad. It is located, in most cases, near the oil filter. It is a $10 part and simply screws in and a wire hooks to it.

On 3.0L OHV engines, the oil pressure sensor is located on the left side of the engine block above the flywheel. On 3.0L DOHC engines the sensor is located on the left side of the engine block above the oil filter. On 3.4L DOHC engines the sensor is screwed into the oil filter adapter. The oil pressure sensor operates the oil pressure warning lamp.


Fig. 1: Location of the oil pressure sensor-3.0L OHV engines


Fig. 2: Location of the oil pressure sensor-3.0L DOHC engines



Fig. 3. The oil pressure sensor-3.0L OHV engine

Hope help with this (remember rated this help). Good luck.

The oil pressure sending unit is located on the engine block, passenger side by the Distributor. Good luck and make sure you get the right sending unit, there is the simple unit that only turns on a low oil pressure light and the other will send signals to the oil pressure gauge.

To locate the oil pressure sending unit, locate the oil filter and look above it and to the right, above the starter. You will see a long round sensor, this is the oil pressure sending unit. It screws into the engine block and when you remove it you will get a dribble of oil.

Just wondering if you put in the correct amount of oil and tightened everything back up properly...

It could be the sending unit,but it could also be the high pressure bypass on the oil pump itself,the sending unit will be on the side of the motor usually close to the oil filter.

Check drivers side of engine, near front of engine, under exhaust manifold, screwed into engine block.

The oil pressure sending unit is located behind the oil filter.

The oil pressure switch (also known as the oil press. sending unit) is located above the oil filter, mounted on the engine block. It is a $6 part in my area, just by chance if that's all that's wrong, I'd replace it. Hopefully it is that simple. If not, time for an oil pump? If u remove it, and crank the engine, there should be a steady flow of oil, if not then it's the pump. Good luck.