SOURCE: how to replace a jeep tj fuel tank?
I would be really careful with doing this repair as this is very dangerous. You need to relieve the fuel pressure by pulling the fuel pump fuse and starting the truck. Drain the tank with a siphon pump. Remove any exhaust or other parts that are in the way, loosen the straps and support the tank with a floor jack and a block of wood. There are several hoses, and a few wire connectors to disconnect and you may want to replace those hoses while you're down there. Once you put the new tank in, reconnect the electrical and hoses, raise the tank and strap it back up. Put anything else back together you took off the truck.
Personally, I would take this in to get fixed as this is dangerous work (I did mention that). I you do this anyway, use your head and buy a proper container to hold the gas in , as well as jackstands and a class "B" fire extinguisher. Disconnect the battery and don't smoke or use a drop light under the car, and I will not accept responsibility for this.
SOURCE: 92 Jeep Wrangler MAP sensor bad?
This may not be your MAP but your Catlettic Converter. I also own a 92 Wrangler and had some of the same issues. My issue was actually a couple of things but they all came from a crack in my exhaust headder.
You may want to check your exhaust headder for cracks. If there is even a small one, (which are VERY common w/ YJ's) than your O2 sensor is thinking that the engine is running too lean. Therefor telling the fuel pump and injectors to dump more fuel into the engine. Well, truth is your not running too lean, in fact, you begin running too ritch.
The unburned fuel that is now comming out through your exhaust collects on the porslen screen inside your catalettic converter where it burns off, causing the screen to melt together. Resulting in a clogged cat.
The only way to fix this is to replace the ehaust headder (welding the crack will not work) and replacing the cat. This would explane your loss in gas mileage and power, due to over back pressure. The ticking sounds like the back pressure working on your valves.
Hopefully I'm wrong and this is not your issue because it is a very expencive repare. You're looking at around 350.00 to 500.00 just for a good headder and atleast 250.00 for the cat. However, an easy way to test this is to take a flash light and have a good look at your headder anywhere there are joints where pipes come together. Look for black, ashy spots above and around the joint. If you see this anywhere then I hate to tell you but this mite just be your problem.
SOURCE: jeep wrangelr Crank Position Sensor
wall5552: there were two engines used in 1992 Jeep Wranglers.
A 2.5 liter and a 4.0 liter. HOWEVER>>>> The location for the crank angle sensor is the same for both.
It is located on the bell housing up near the front at about the 10:00 PM position.
The Cam position sensor is located in the Distributor on both engines as well.
SOURCE: 2006 jeep wrangler check engine light came on it
There is a software update for the PCM that addresses this issue. TSB 18-028-06
SOURCE: where is the map sensor located? 1994 jeep grand cherokee
Go half way between the air cleaner box and the "carburetor". Up the 4" black air pipe, a wire harness plug plugs into the MAP sensor there. Also called MAS air flow sensor.
485 views
Usually answered in minutes!
×