1999 crown victoria where is the temperature sending unit located

SOURCE: Where is the fuse panel on a 1985 Ford Crown Vic located?

Local Ford dealership service department provide answer on location of the fuse panel. Fuse panel is located directly under the steering column. The cover panel is held by two screws and the power antenna swithch locking ring must be removed.

thank you all for you assistance,

SOURCE: fuse box diagram

Locations In Case this Picture Doen not SHOW UP FOR YA --
WIPER Fuse ok Lookin at the box with the Round Circle In TOP RIGHT Corner Wiper is Number 2 Bottom from That Circle would be 2nd one from right Suppose to Be a 30 amp fuse Hopin this Helps Ya If so Please RATE Me AS High as You feel I Dererve Thank You and Good Luck with the CROWN VIC
Notes

SOURCE: 92 crown vic - temperature guage on the dash is not working...

The temperature gauge sending unit is located in the front section of the intake manifold, just to the right of the alternator on the 4.6L engines. Got this from autozones repair manuals

SOURCE: Engine light on coolant light

the DTC P1299 is "Cylinder head over limit protection" It cam one when your coolant light did to warn you the moor got to hot. Check your coolant level then make sure your thermostat and fans are working properly.

SOURCE: no power to fuel pump

Hello abzalkhan193
Heres a few things to check that could cut power to the fuel pump. The fuel pump inertia shutoff sw
in the trunk on the left side, there is a reset button on the switch if you push the button down and
you hear/feel a click then the switch was tripped and you just reset it. The switch's job is to cut off
the fuel in case of an accident. Next, the fuel pump fuse located in the battery fuse block under the
hood on the right fender well, fuse #1 20amp fuse. Next, the fuel pump relay, the relay is located in
relay center on the left fender well. Hope this is helpful.