:Remove key switch on `91 Ford Taurus?

Replacement Ignition lock cyclinder for 1991 - Taurus Car Club of ...

www.taurusclub.com > ... > Maintenance and Repair

May 21, 2014 - I have a Ford Taurus 1991 6cyl 3.0L. I am looking on the RockAuto site. ... Drives: '90 Taurus GL Wagon 3.0L; '65 Rambler Ambassador 990 convertible ... I have the key code for the Ford, but do not know how to relate it to ... Ignition Problems
Apr 9, 2012
Lost Keys
Sep 24, 2006
Ignition Problem: Car Wont Start & Key's Loose?
Apr 25, 2006
Programming Pats, Keyfobs, & Keyless Entry
Jul 7, 2004
More results from www.taurusclub.com

Ford Keying Systems - How They Work - Taurus & Sable ...

www.taurusowners.com > ... > Maintenance & Repair

Jul 22, 2013 - 5 posts - ‎4 authors
The square-head 10-bit key operates the ignition and door locks, and the ... I believe the first three digits are the ignition code and the last three are the door code. ... 1992Ford Taurus GL wagon - 232 - sold, was later wrecked ... --Beige 1991 Mercury Grand Marquis LS Colony Park Wagon ' 5.0 V8/AOD ...

Ford 10 Cut Ignition Svc. - YouTube

? 13:45
https://www.youtube.com/watch?v=r6mposGhsuI
Sep 23, 2010 - Uploaded by William Mcintosh
Ford, 10-cut ignition removal and new ignition installation process. ... I have an 91 windstar, lost key and ...

spark plugs work better when theyre hot so change spark plugs,

I looked at info for your security system, it is starter motor disable. I didn't see 06 ford Taurus in my database, so I looked at 05.
Battery has a full charge and battery connections all good?
We can usually do some tests to see if starter motor will crank the engine, but, if the security is the problem, it still won't start.
You can check for applicable trouble codes? Try a different key?

Maybe worth checking wiper switch or wiper motor.If you have a multi-meter it maybe worth checking power supply to switch and motor..hope it helps.....

Inspect/Test/Replace The ignition switch is usually mounted to the steering column and is operated by a linkage rod.
NOTE On column-mounted ignition switches, don't confuse the switch with the lock cylinder and keys. The ignition switch is not normally visible. On some vehicles, the steering column support has to be removed and the column lowered to find the ignition switch. On others, the switch is accessible under the dash.
The ignition switch is operated by the key switch. Courtesy of Ford Motor Company. To replace the switch:

• Remove the ignition switch wiring harness.
• Unbolt it from its position.
• Bolt the new switch into position.
• Attach the witing harness.

You need a puller.

u should get a haynes repair book, for the car u have,,it will give step by step info on how to do it,,because theirs a lot to do ,,,

there would be more time and work involved with replacing wiring and ecu. i would never attemp.

key switch?then turn the key to acc,first spot where the radio comes on ,then pull off the plastic steering column cover on the bottom just under the switch,and push a paper clip in the tiny hole under the switch and wiggle the key switch out.if you dont have a key i would recommend a lock smith to pull out the switch because the switch has to turn to acc in order to remove it...if you are talking about the actual ignition switch,its at the bottom of the steering column with 2 little bolts and 1 long wiring plug

most likely right on top of steering colum around have way down