20 Most Recent 1994 Ford Taurus Questions & Answers

Check the voltage on your battery. When the battery is low, you will still have lights and what not but not enough juice to start the car. Check the condition of your battery cables especially your ground. If everything check out fine, your problem may be a bad starter or the solenoid. If you replace the starter, replace the solenoid with it. Be sure to check the cable from the starter solenoid to the starter.

1994 Ford Taurus | Answered on Jun 16, 2019

Problem with hot wiring the ignition is that the vehicle will start and run but with out turning the ignition the steering wheel will be locked > I suggest a new ignition switch , you can always hammer a flat head screw driver in the ignition were the key goes and turn the ignition. Either way you will need a new ignition switch .

1994 Ford Taurus | Answered on Mar 29, 2019

Replaced ICRM ??? The CCRM - the constant control relay module controls the cooling fans along with input from the PCM - engine computer . Engine coolant temp. sensor is a input to the PCM . Wiring diagram here http://www.bbbind.com/free_tsb.html

1994 Ford Taurus | Answered on Jul 10, 2017

try resetting the inertia switch the owners guide might tell where it is located at some are under the hood in the trunk, or in a kick panel around under the dash

1994 Ford Taurus | Answered on May 04, 2017

run the fault codes to check for the problem
Most likely in the ambient temp sensor , baro sensor or MAF/VAF sensors

1994 Ford Taurus | Answered on Apr 24, 2017

Just cap it off or plug it somehow.

1994 Ford Taurus | Answered on Mar 03, 2017

Google this: DAYCO Serpentine belt routing diagrams.

1994 Ford Taurus | Answered on Feb 27, 2017

The radiator takes antifreeze ! The trans fluid goes in the trans mission only ,not in the radiator ! Try you tube !

1994 Ford Taurus | Answered on Nov 12, 2016

I don't have the diagram but I can get you one and post it. I have taken many of these apart, Is there any questions I can answer. I know the AXOD-E like the back of my hand.

1994 Ford Taurus | Answered on Oct 21, 2016

check the drive system for the distributor
ford employ a shaft that drives the oil pump and if the oil pump is under undue stress, it strips the gear or breaks a shear pin
all the gear is driving is a distributor shaft and in the first instance could be a seized bush for the shaft but with replacements failing I would be looking further afield , like an oil pump

1994 Ford Taurus | Answered on Apr 04, 2016

may just need cleaning with carb cleaner.

here is 1996, oldest I have:

Section 03-14: Engine Controls, Electronic 1996 Taurus, Sable Workshop Manual
REMOVAL AND INSTALLATION Idle Air Control (IAC) Valve Removal
  1. Disconnect battery ground cable (14301). Refer to Section 14-01 .
  1. Disconnect the engine control sensor wiring (12A581) from the idle air control valve (IAC valve) (9F715) at the idle air control valve electrical connector.
  1. Remove the two idle air control valve retaining bolts.
  1. Remove the idle air control valve and idle air control valve gasket.
  1. NOTE: If scraping is necessary, be careful not to damage idle air control valve gasket surfaces, or drop material into intake manifold (9424) or throttle body (9E926) (depending upon application).

    Clean idle air control valve gasket mating surfaces.
  1. To install idle air control valve, reverse Removal procedure.
  1. Tighten the idle air control valve retaining bolts to 8-12 Nm (71-106 lb-in).

1994 Ford Taurus | Answered on Mar 03, 2016

Does the vehicle have auto lamps ? There would only be a relay if the vehicle had auto lamps ! An does it happen in auto or regular headlamps ?

1994 Ford Taurus | Answered on Feb 10, 2016

Your best bet is finding a shop book for your car. Just asking for a diagram is too general.

1994 Ford Taurus | Answered on Dec 26, 2015

There really isn't a step-by-step set of instructions with visual aid. It is simple to do a swap out. The module is located on the driver's side firewall under the rubber/plastic cover where all the wiring feeds into.. Two fasteners to remove the module with connector attatched and one more in the middle holding the connector to the module.

1994 Ford Taurus | Answered on May 27, 2015

If you have a distributor, the tfi module, is a known problem on some ford models.

How long since a tune-up?

1994 Ford Taurus | Answered on May 26, 2015

does putting heater on hot prduce hot air.on full with fan on does it reduce temo?is ur radiator fan coming on? hard to give one answer.as dont know if its overheating in traffic or on the move?there could be air stuck in pipes slowing water flow.or a pipe/radiator blockage so coolant doesnt get to flow around engine so it gets hot.u could check radiator by touching see if hot or cold where pipes enter(prob switch off engine first) try bleeding system squeesing pipes to push air out

1994 Ford Taurus | Answered on May 21, 2015

maybe a can of injector cleaner in a fresh tank of gas will help

1994 Ford Taurus | Answered on May 01, 2015

Not finding what you are looking for?

895 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

1999 Ford Taurus
1999 Ford Taurus

2,300 Questions

2001 Ford Taurus
2001 Ford Taurus

2,217 Questions

2000 Ford Taurus
2000 Ford Taurus

2,060 Questions

2002 Ford Taurus
2002 Ford Taurus

1,831 Questions

1998 Ford Taurus
1998 Ford Taurus

1,403 Questions

Top Ford Experts


Level 3 Expert

85239 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

gerry bissi

Level 3 Expert

4388 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Taurus Ford

  • Taurus Ford

Most Popular Question

1994 ford taurus new plugs new

  • Cars & Trucks