SOURCE: looking for step by step procedure to replace a
To do this job you will need a lot of time and above average skill level. You will need a good flat place to work, a good floor jack and a fixture to keep the engine from falling, and a pilot bar to align the clutch disc.. The actual instructions can be found in any decent manual...(chiltons, haynes etc) but art too long to re-write here. if you have any specific questions along the way post back and I'm sure someone will help out!!!
good luck!
SOURCE: change water pump on 2001 hyundai tiburon
It is a 2.0L (the delta blocks weren't in tibs until '03). You have to remove the timing belt tensioner, and then you can remove the bolts for the water pump. I would strongly recommend not only taking careful precaution not to disturb the orientation of the gears in this process, but also to replace the timing belt and water pump at the same time. You don't want to go through this process all over again do you?
SOURCE: Need Instructions on 2003 Hyundai Tiburon Clutch Replacement
Go to http://www.hmaservice.com/ and register (vehicle by VIN). Afterward, you'll have access to technical information (manuals, wiring diagrams, service bulletins, etc) about your vehicle.
SOURCE: how d i change a clutch in a hyundai excel 1994
Hi first lift the car and be sure to secure the car that it wouldn't fall when your under the car, remove the wheels then disconnect the negative cable from the battery remove the axles, remove the transmission mount, remove the starter, remove the bolts around the transmission housing once you remove the bolts use a floor jack and put it under the transmission then use a prior and separate the tranny from the engine and bring the tranny to the floor now you have the clutch expose remove the old clutch and pressure plate and pilot bearing now do the same thing in reverse good luck
64 views
Usually answered in minutes!
×