2005 Chevrolet Impala Logo
john elliott Posted on Jan 28, 2013
Answered by a Fixya Expert

Trustworthy Expert Solutions

At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.

View Our Top Experts

Door bell rings when key is out and drivers side door is opened on my 2005 chevy impala

How do i stop the door bell ?

1 Answer

Stephen

Level 3:

An expert who has achieved level 3 by getting 1000 points

Top Expert:

An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

  • Chevrolet Master 21,873 Answers
  • Posted on Jan 28, 2013
 Stephen
Chevrolet Master
Level 3:

An expert who has achieved level 3 by getting 1000 points

Top Expert:

An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

Joined: Jun 22, 2012
Answers
21873
Questions
0
Helped
6210162
Points
67230

Assuming the warning is for the key in the ignition, the problem could be the sensor inside the steering lock cylinder.

5 Related Answers

Anonymous

  • 206 Answers
  • Posted on Mar 29, 2009

SOURCE: 2005 chevy impala rear driver power window stopped going up.stuck

If neither switch works it is a bad connection at the motor or bad ground or a bad motor. Remove the door panel unplug the motor push the switch and see if there is 12volts on the wires if there is the motor is bad There are small brushes in the motor that go bad tap on the motor while pushing the switch if it works that way replace it

Ad

Anonymous

  • 491 Answers
  • Posted on Nov 03, 2009

SOURCE: 2005 Chevy Impala driver's side heat blows cold.

First....buy a drivers side air flow actuator at a auto parts place for dual zone heating/cooling.
(NAPA etc will have it.....or the dealer)
Open the glove compartment.....all the way....you may have to take the screws out at the bottom......look in at the heater assembly....look over to the left....you will see the two air flow actuators.
Look at the part you have and match it to the part on the heater assembly.
The actuator that is closest to the engine is the drivers side control.
Replace it.
Try your controls and check for heat and cooling on both sides.
The stepper motor in these actuators goes bad on quite a few...but over look that.....you have a great car,good for many miles of trouble free driving.


Anonymous

  • 416 Answers
  • Posted on Feb 18, 2010

SOURCE: chevy 2005 impala

sounds like you have a bad actuator motor that make temp go hot to cold

john h

  • 29494 Answers
  • Posted on Mar 13, 2010

SOURCE: 2007 chevy tahoe driver side door handle will not open door

the linkage behind the handle either the retaining clip broke or popped off need to remove the door panel to check and fix

Testimonial: "Thanks I thought it might be a cable or linkage. Much thanks"

Anonymous

  • 15 Answers
  • Posted on Apr 06, 2010

SOURCE: good afternoon....what would cause my 2008 Chevy

It could be the power lock motor. You could have a short or bad wiring harness. Might just be a fuse that connects to both. But since you said it's only the driver side. When the power lock motor is bad it can trigger your alarm because they're wired together.

Hope that helps. Good luck.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
3answers

Door bell wont stop ringing

answer the door.. lol..pull plug on the door bell....unscrew the ringer and remove the wiring from the door bell...the door bell switch is stuck.
3helpful
2answers

While driving a bell ringing happens when i make a right turn. sometimes the bell rings continually while i'm driving. what the problem?

Sounds silly but this is how i fixed my bell ringing. !st the ringing is the alarm when you open the door and the key is in the ignition or the car is running. I found the push switches that are on the side of the car and are operated when the door is shut have become loose. All you need to do is tighten them up a bit and the bell ringing will stop. When you make your right turn you probably push a bit on the door and that helps open the switch more. The switches are the contact switches that turn on the light as well as the warning sensors for open door. See if your dome lights flicker a bit as well.
2helpful
2answers

My door chimer won;t stop ringing it;s driving me crazy help

Look for the plunger coming out of the frame where the door hinge is. Is it broken? When you open the door the plunger is released (comes out) and grounds sending the signal to chime, however this should only happen if your lights are on or key is in. The chime controller may have failed and that's why it also could stay on. Does it happen when the key is in, while driving, or even always stays on? Need more info.
0helpful
1answer

Bell rings when I pull the key out and open the driver door

Replace the ignition switch or take to a dealer they may be able to repair the switch.
1helpful
1answer

Chevy Impala Door lock issue

Which is it, 98 Eclipse, or 06 Impala? Either way, your door lock actuator is stuck in the locked position either electrically or mechaically. The way to check this is to remove the door panel and unplug the actuator. If door lock can now be moved then you have an electrical problem (faulty door lock switch or faulty door lock module). If you still cannot unlock door then actuator is mechanically bad and must be replace (usually the case)
0helpful
1answer

The door bell on my chevy impala is not working and the warning bell for the keys left in the ignition switch isn' either.

the bell as you call it is located in the fuse panel,probably went bad easy and fairly cheep to replace.
0helpful
1answer

Bell sound will not stop.

Hey Wizz,
Have you checked the "closed door" plungers?
My neighbor had the same problem. I found it to be the drivers side plunger. The plastic retaining ring had broken, leaving the curcuit open. Being two months later, I hope you have found it.
I drove it a half mile...... It was like Chinese water torture. AHHHHHHHHHHH!

Hope this helps.
Matt
2helpful
2answers

2005 chevy impala rear driver power window stopped going up.stuck

If neither switch works it is a bad connection at the motor or bad ground or a bad motor. Remove the door panel unplug the motor push the switch and see if there is 12volts on the wires if there is the motor is bad There are small brushes in the motor that go bad tap on the motor while pushing the switch if it works that way replace it
1helpful
1answer

Bell ringing

the switch that shuts off the dome light and chime is part of the door latch and is broken
Not finding what you are looking for?

470 views

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...