(1) what type of engine oil to use for a change on a 1999 chevy silverado k1500 (2) drivers power window inoperable

After changing the oil and filter, reset the monitor by proceeding as follows:

Turn ignition On, but do not start engine.

Fully depress and release accelerator pedal three times within five seconds.

If CHANGE ENGINE OIL lamp flashes for five seconds, this indicates system has reset.

Start engine. OIL LIFE should change to 100%.

If CHANGE OIL SOON lamp lights again, repeat reset procedure.

2001-08 Silverado, w/Driver Information Center

Turn ignition On, but do not start engine.

Press MODE button until DIC (Driver Information Center) reads OIL LIFE LEFT/HOLD SET TO RESET.

Press and hold SET button until 100 percent is displayed. You will hear 3 chimes and CHANGE ENGINE OIL SOON message will go off.

Turn ignition Of


how to reset oil life on 2004 chevy silverado

Yes it is telling you to change the oil in the truck.

Motor is not turning in second direction to lower window. Either the new motor is defective or the device that reverses the electricity to the motor is defective. Regulator?

Take motor out and feed it juice - will turn. Reverse polarity and it should turn in other direction.

under the dash in the fuse box, or open the drivers door and take the fuse pannel cover off and replace the pass window fuse

yes near oil filter and did you change oil latly and didnt remove the old gasket of the filter sometime its sticks to the engine and you dont see it if not sure where the leak is wash engine good and run it for a few minutes to see exactly where leak is

remove the new filter, then remove the gasket from your old filter that is stuck to the engine, reinstall new filter

try changeing the relay switch loacated on drivers side under hood in fuse box from [email protected] hope that works for you

• its a sensor that lets you know to change oil. 1st turn key on start possession don't start, 2nd pump gas pedal three times fast not real fast then after the third time turn key back to off then start the vehicle this should reset the light!!

The fuel pump on that model runs through the oil pressure switch so that if the truck looses oil pressure,It kills power to the fuel pump to prevent engine damage.you need to find the cause of the low oil pressure reading(possibly a bad oil switch).That would be the cheapest place to start,or have it checked with a mechanical gauge.Good luck,
ChevRev

the oil sending unit is located at the back of the motor right below the rotor cap it is about 3 inches long and has a 3 wire plug hooked t it