How to remove front bumper 1999 blazer

crawl under the front of the blazer. the bumper should be bolted to the frame itself. usually 2 on each side.

Hi there:
Check this Removal Procedure...



1. Remove the rear bumper step pads.
2. Remove the license plate lamps.
3. Remove the nuts and the bolts that retain the rear bumper impact bar to the bumper bracket.
4. Remove the rear bumper impact bar from the vehicle.

Installation Procedure



Notice: Refer to Fastener Notice in Service Precautions.

1. Install the rear bumper impact bar to the vehicle as follows:

1.1. Position the bumper impact bar on the bumper brackets so that the holes in the impact bar are aligned with the bracket holes.
1.2. Install 2 bolt plates and 4 nuts on top of the impact bar.
1.3. Install 2 bolt and nuts through the bottom of the impact bar. Tighten the rear bumper impact bar nuts to 90 N.m (66 lb ft).

2. Install the license plate lamps.
3. Install the rear bumper step pads.


Hope this helps; also keep in mind that your feedback is important and I`ll appreciate your time and consideration if you leave some testimonial comment about this answer.

Thank you for using FixYa, have a nice day.

Impact sensor Front sensor = Right side 16240655
Left side 16240655

Before repairing any restraint system battery must be disconnected and any other power supply must be disconnected

I have a brand new chrome front bumper that I bought for a 1997 Rodeo.

Email me if you are interested in it. [email protected]

I think on that year its behind the front bumper look in the plastic skid plate there should be a little door that opens with a flat screwdriver

Front or rear, I am guessing it is the rear as they tend to get the most abuse and or rust! Start by removing the plastic step guard on the top of the bumper (use a flat ply bar) you will see the four bolts (remove those) and directly inline with those from the underside you will see four more (remove those) your bumper is free, there is one wire connector to release (licence plate lights) and simple lift off the bumper.

Front

1. Note the radio security code, then disconnect the negative battery cable.
   
2. Remove the bolt from the lower part of the bumper just in front of the wheel opening, and remove the self-tapping screw from the rear most portion of the bumper at the forward portion of the front wheel well.
   
3. On V6 Odyssey models, perform the following:
   
   • Remove the grille.
     
   • Remove the pins and clips from the lower front of the bumper.
     
4. On 4-cylinder Odyssey models, remove the bolts from the left and right side lower brackets for the bumper at the ends of the lower air intake.
   
5. Pull the ends of the bumper outward.
   
6. Have an assistant help guide the bumper up and away from the vehicle.
   
7. Installation is the reverse of the removal procedure.
   

The strip is held on with really tacky glue. You will have to pry off one end and pull off the remainder of the strip.

7/16th or 10mm Sheetmetal nuts All over Behind the Bumper Thak Bumper off first

If your turning your car to the right when it make the noise or the Left Listen and find out because which ever way the noise is loudest usually meaning that is the side going bad, Thats the rule Usually some cars and trucks have fronts and rear bearings, But I think it is a wheel bearing, Have a mechanic or a friend that may turn some wrench's Check it out for you. Hope that helps you out. :))