I want to remove the computer from a 1999 nissan maxima SE, but i can't find the computer.
HI, the cost of the ignition switch is $27.99. the labor cost is usually figure by the hour and it is set a 50 dollar an hour increment. In my shop, we have a set minimum labor charge of two hour as most shops in my area. Total estimated cost including the labor and parts should be around $127.99 give or take.
You can most certainly purchase this part yourself on-line at www.autozone.com
Part Number is - LS812
OEM Number---- 48750- 1E411
Please rate and god bless:)
SOURCE: 2005 Nissan Maxima SE Fog light replacement
jorgeva: on the driver's side to gain access, you must remove the air cleaner assembly. At that point, you can see the back of the light which has a plastic cap. Rotate this "counter clockwise" and you can pull it back from the back of the lamp housing. From there you will see how the bulb it self is plugged in, which is obvious. Unplug it. There is a "spring "like latch retainer to hold the bulb in place. Unlatch it, remove the bulb and install the new bulb.
CAUTION!!!!!!! DO NOT TOUCH THE GLASS AREA OF THE NEW BULB! Only handle the rear section. Reassemble in the reverse order.
The right side will require the removal of the windshield washer tank.
I trust this will have answered your question. If you would, let me or FIXYA know if I have solved your problem......
SOURCE: FILLING UP THE FREON IN MY 2000 NISSAN MAXIMA SE
2000 maxima is filled with R134, not freon. You don't need retro fit kit. Get couple of cans of R134 and pump it into the low side valve /small fiting, while A/C compressor is engaged. If your compressor is not coming on, jump the low side pressure switch to make the compressor come on and than the R134 will get sucked in to your system through the low side line. The proper way to do this is to put a/c system under vaccum for 15 minutes at least and watch for leak/gauges coming/loosing vaccum. Than pump R134 into the HIGH side valve with engine OFF.
SOURCE: 1992 nissan maxima se. my right headlight doesn't
check all fuses , they sometimes pop fuse when bulb blows.good luck.
1,906 views
Usually answered in minutes!
how do i remove the cover to get to the computer, i don't see any screws in the cover, do i need a special tool to remove the cover.
there are no scrwews. just 2black clips that hold it in. pull out those clips. no tools needed. just jank on the cover where the clips are. those are push in clips.
I haven't seen any clips on the cover, are they on the inside of the cover.
yes, its 2 black round push pins/clips about 3/4 of an inch . pull those out and remove cover
×