Just did it - was easy!
1. Turn the tire fully inward on the side with the bulb burned out
2. Remove the 5 phillips head screws securing the tire shroud to the fender
3. Flex the tire shroud away from the fender and slip your hand in; turn the bulb holder for the daytime running light 1/3 counter clockwise and remove it from the housing
4. Pull the 3157 bulb straight out and replace it with a new one (push straight in to put the new bulb into the holder)
5. Replace the bulb holder into the housing by inserting it and turning 1/3 clockwise. IMPORTANT NOTE: one tab on the holder is larger than the others - this tab faces forward to the front of the car (this way the filament will be parallel to the front of the car when secured so the light shines correctly and fully)
6. Replace the 5 screws to secure the shroud to the fender.
That's it!!
SOURCE: Replace 2005 GMC Sierra Daytime Running Lights...
Open the hood, and in the top right and left corners of the primary headlamps you'll see two pins (L shaped) swing them out (towards the front of the truck) and lift out. This allows you to remove the upper headlamp assembly. You can then remove the lower assembly by pushing outwards on the plastic clip that is hooked into a metal clip. Once it's out you just turn the bulb to remove it.
It's much easier if you unhook the leads to the upper assembly's bulbes so you can set the whole thing aside.
SOURCE: how to replace a daytime running light bulb, ona
you should be able to access the bulb from inside the engine compartment at the rear of the headlight assembly. the connector that holds the bulb in usually has a large O ring. give it a half turn and it should come off. pull the bulb back out of the housing and replace it with a new one. be VERY CAREFUL not to touch the bulb with your fingers as it will shorten the life of the bulb.
please take a moment to rate this solution thanks
robert
Testimonial: "not a good advice"
SOURCE: replacing daytime running lights on 2000 chevy tahoe
first you have to lift the hood then remove the headlight pins and then stick you're hand down on the left side push the clip in and gently pull the housing out then push the white clip andturn the housing counter clock wise and pull out
SOURCE: Location of batter 2010 Enclave
You will probably find the battery under the hood on the left or right in this vehicle and the fuses box under the left hand side dash by the driver. But it may be on the right hand side under the dash too. Easy to find either way. Hope this helps and you have a kind heart to give me a good thumbs up, Raz
7,931 views
Usually answered in minutes!
Dave Stern is right! It\'s easy...BUT a pain for such a normal maintainence item!
Apparently I said a bad word...so just change that to keister...
It was easy the dealer wanted $80.00 for the job bulb was $1.49..
×