20 Most Recent
1978 Chevrolet Chevette Questions & Answers
My 78 chevette kept stalling on me, pulled the air
It could be the crank case breather is blocked up with deposits . It's normally found on the rocker box cover . If you clean this and make sure the hoses are clean our replace them it should cure your problem.
No brakes! Pressure dropped
fill up your brake fluid,
have someone step on the brakes, while you look to see where it is leaking from..
if you cant see in properly, remove the wheel..
steel brake lines?...probably rusted out from normal aging..
you may have to wipe down the lines with a rag 1st, to clean them up a bit, before looking for leaks.
hope this helps.
let me know
My windshield wipers quit working.
one wire will be power one wire will low speed wiper and one wire will be high speed wiper.you need to check the grounding of the wiper motor.if you take a jumper wire and attach one end to the battery, or a good ground at the motor or somewhere and the other end then make good contact to the body of the wiper motor and it should work,if it does then you need to permantly hook up a ground wire to the wiper motor.this was a common problem.
87 chevette instrumental panel fuse keeps blowing
install a test light (12v bulb) or a buzzer in palce of the fuse. When you get the light or buzzer to stop, you will have found the short circuit. Look in the owner manual for what this fuse protects.
Need to know how to remove the back seat in
Get a number 10 metric or a 7/16" socket and feel at the base of the seat bottom....should be two bolts holding the seat to the floor one on each side, use your light and perhaps you will need to peel back the carpet going to the seat bottom.
Happy Motoring!!
What is the proper timing on a 1978 Chevrolet
My Motor book gives no timing for your engine that year, which suggests that it is preset. However that size engine ( should be a 97 cu. in. or 1600cc) for the 2 years before shows 8 degrees before TDC for a manual trans and 10 for an automatic. Hope this helps.
Solex h32/34 pdsi-3
Go to the parts store and order a rebuild kit,it will have a break down of the carburetor in it,and the adjustments
Not finding what you are looking for?